User manual
Table Of Contents
- About Operating Instructions
- Chapters
- Contents
- Contents by Function
- 1. Introduction
- 2. Getting Started
- 3. Basic Operations
- 4. Image Recording
- 5. Focus/Zoom
- 6. Drive/Shutter/Image Stabiliser
- Selecting the Drive Mode
- Taking Burst Pictures
- 6K/4K Photo Recording
- Selecting Pictures from a 6K/4K Burst File
- Recording with Time Lapse Shot
- Recording with Stop Motion Animation
- Time Lapse Shot/Stop Motion Animation Videos
- Recording Using the Self-timer
- Bracket Recording
- Post-Focus Recording
- [Silent Mode]
- [Shutter Type]
- Image Stabiliser
- 7. Metering/Exposure/ISO Sensitivity
- 8. White Balance/Image Quality
- 9. Flash
- 10. Recording Videos
- 11. Special Video Recording
- 12. Connections with External Devices (Video)
- 13. Playing Back and Editing of Images
- 14. Camera Customisation
- 15. Menu Guide
- 16. Wi-Fi/Bluetooth
- 17. Connecting to Other Devices
- 18. Materials
- Using Optional Accessories
- Monitor/Viewfinder Displays
- Message Displays
- Troubleshooting
- Cautions for Use
- Number of Pictures That Can Be Taken and Available Recording Time with the Battery
- Number of Still Images That Can Be Taken and Video Recording Time with Cards
- List of Default Settings/Custom Saving/Settings Available for Copying
- List of Functions That Can Be Set in Each Recording Mode
- Specifications
- Index
- Trademarks and Licences
2. Getting Started
49
Card Access Indications
The card access light turns on while the
card is being accessed.
Removing a Card
1
Open the card door.
0
Check that the card access light A is
turned off and then open the card door.
2
Push the card until it clicks and then
pull the card out straight.
0 You can set the way to record to card slots 1 and 2:
[] ¨ [ ] ¨ [Double Card Slot Function] (l 92)
0 The card may be warm just after the camera has been used. Be careful when
removing.
0 Do not perform the following operations during access.
The camera may operate incorrectly or the card and recorded images
may be damaged.
– Turn off the camera.
– Remove the battery or card or disconnect the power plug.
– Subject the camera to vibration, impacts, or static electricity.
0 You can set so that the card access light does not turn on:
[] ¨ [ ] ¨ [Card Access Light] (l 452)