User manual
Table Of Contents
- About Operating Instructions
- Chapters
- Contents
- Contents by Function
- 1. Introduction
- 2. Getting Started
- 3. Basic Operations
- 4. Image Recording
- 5. Focus/Zoom
- 6. Drive/Shutter/Image Stabiliser
- Selecting the Drive Mode
- Taking Burst Pictures
- 6K/4K Photo Recording
- Selecting Pictures from a 6K/4K Burst File
- Recording with Time Lapse Shot
- Recording with Stop Motion Animation
- Time Lapse Shot/Stop Motion Animation Videos
- Recording Using the Self-timer
- Bracket Recording
- Post-Focus Recording
- [Silent Mode]
- [Shutter Type]
- Image Stabiliser
- 7. Metering/Exposure/ISO Sensitivity
- 8. White Balance/Image Quality
- 9. Flash
- 10. Recording Videos
- 11. Special Video Recording
- 12. Connections with External Devices (Video)
- 13. Playing Back and Editing of Images
- 14. Camera Customisation
- 15. Menu Guide
- 16. Wi-Fi/Bluetooth
- 17. Connecting to Other Devices
- 18. Materials
- Using Optional Accessories
- Monitor/Viewfinder Displays
- Message Displays
- Troubleshooting
- Cautions for Use
- Number of Pictures That Can Be Taken and Available Recording Time with the Battery
- Number of Still Images That Can Be Taken and Video Recording Time with Cards
- List of Default Settings/Custom Saving/Settings Available for Copying
- List of Functions That Can Be Set in Each Recording Mode
- Specifications
- Index
- Trademarks and Licences
10. Recording Videos
274
Maintaining, Releasing, and Restoring the Slave State
Even if you disconnect the BNC cable, the camera will remain in slave
state.
0
Perform one of the following operations to release the camera from the slave state.
– Operate the camera on/off switch
– Switch the recording mode
– Change the [System Frequency]
– Set the [Variable Frame Rate]
– Switch the [Rec Quality] between 47.95p/23.98p and a different recording frame
rate
– Change the following [Time Code] setting items
[Count Up], [Time Code Value], [Time Code Mode], [TC Synchronization]
0 To restore the slave state, reconnect the BNC cable to the external device while set
as follows.
The time code signal (LTC signal) can be input just by connecting.
– [ ] mode
– [Count Up] ([Time Code]): [FREE RUN]
– [TC Synchronization] ([External TC Setting] in [Time Code]): [TC IN]
0 Even when the system frequency differs between the camera and the external
device, their initial time code values may be synchronised. Bear in mind,
however, that the time codes lose sync as they count up.