User manual

10. Recording Videos
245
0 When the remaining capacity of the battery or card gets low during video
recording, the tally lamps blink at long intervals. When there is no remaining
capacity in the battery or card, video recording is stopped and the tally lamps
blink at short intervals.
0 If an operation such as a zoom or button operation is performed during video
recording, that operation sound may be recorded.
0 The lens operation sound (AF and image stabiliser) may be recorded to video.
0 If the operation sound of pressing the video rec. button or sub video rec.
button to end recording bothers you, try the following:
– Record the video about 3 seconds longer, and then divide the last part of the
video using [Video Divide] in the [Playback] ([Edit Image]) menu.
– Use the Shutter Remote Control (DMW-RS2: optional) for recording.
0 Depending on the type of card, the card access indication may appear for a
while after video recording. This is not a malfunction.
0 Even when playback is performed on a supported device, situations may
occur where image or sound quality is poor, recording information is not
displayed correctly, or playback is not possible, for example.
If you experience any of these, play them back on the camera.
0 If the camera temperature rises under the any of following conditions, [ ]
may be displayed and recording may stop. Wait until the camera cools down.
– During continuous video recording
– When the ambient temperature is high
0 Video recording is not possible while you are using the following functions:
– [Time Lapse Shot]
– [Stop Motion Animation]
– [Rough Monochrome]/[Silky Monochrome]/[Soft Focus]/[Star Filter]/
[Sunshine] ([Filter Settings])
– [HLG Photo]
– [Post-Focus]