Basic Operating Instructions

18. Materials
DVQX1944 (ENG)
194
0 The wireless access point information set on the camera is wrong.
Check the authentication type and encryption key.
0 Radio waves from other devices may block the connection to a wireless access
point.
Check the status of other devices that are connected to the wireless access point as
well as the status of other wireless devices.
0 Images that do not comply with the DCF standard cannot be deleted.
Back up any necessary data before formatting the card. (l 37)
0 Turn off and on the camera.
If the message is displayed even when doing this several times, contact the dealer.
0 The fan has stopped. Turn off and on the camera. If the fan does not work after
turning the camera off and then on again, consult the dealer.
0 The temperature of the camera will rise if you continue to use the camera with the
fan stopped. Do not use over long periods of time.
First, try out the following procedures (l 194 to 199).
0
Please also refer to the “Operating Instructions” (PDF format), which describes more
detailed information.
0 When [6K/4K Pre-Burst] or [Pre-Burst Recording] is set, the battery drains faster.
Set these settings only when recording.
[Failed to connect wireless access point]/[Connection failed]/[No
destination found]
[Some pictures cannot be deleted]/[This picture cannot be deleted]
[Please turn camera off and then on again]/[System Error]
[The fan is not functioning correctly.]
Troubleshooting
If the problem is not resolved, it may be improved by selecting
[Reset] (l 57) on the [Setup] ([Setting]) menu.
The battery becomes flat too quickly.
DC-S1HMST-DVQX1944_eng.book 194 ページ ２０１９年８月８日 木曜日 午前１１時３０分