Basic Operating Instructions

16. Wi-Fi/Bluetooth
DVQX1944 (ENG)
173
Operating the camera in accordance with the smartphone guide.
3
Set the camera to Bluetooth
pairing standby state.
≥ ¨ [ ] ¨ [ ] ¨ [Bluetooth]
¨ [Bluetooth] ¨ [SET] ¨ [Pairing]
≥The camera enters pairing standby
state and the device name A is
displayed.
4
On the smartphone, select the
camera’s device name.
0 (iOS devices) When a message to
confirm the change of destination is
displayed, select [Join].
5
When a message indicating
that device registration is
complete, select [OK].
≥A Bluetooth connection between
the camera and the smartphone will
be made.
0 The paired smartphone is registered as a paired device.
0 During Bluetooth connection, [ ] is displayed in the recording screen.
When the Bluetooth function is enabled, but a connection is not established
with the smartphone, [ ] appears translucent.
0 (iOS devices) If the Wi-Fi connection attempt fails during Bluetooth
connection, follow the message displayed to allow connection to the camera.
If you still cannot connect, select the SSID of the camera on the Wi-Fi setup
screen of the smartphone to connect. If the SSID is not displayed, turn off and
on the camera, then perform the Bluetooth connection settings again.

XXXXXXXXXXXX
OK
DC-S1HMST-DVQX1944_eng.book 173 ページ ２０１９年８月８日 木曜日 午前１１時３０分