Basic Operating Instructions

Preparation/Basic
17
(ENG) DVQX1515
• Bubbles may come out of the drainage hole when you immerse the camera in
water, but this is not a malfunction.
2 Tap the camera lightly against your palm while holding it upside down
and then with the illustrated side facing down, and then wipe off the
water droplets with a soft, dry cloth.
• Repeat this step a few times if water is left in the microphone A or speaker B hole.
If water is left in the microphone or speaker hole, weak or distorted audio may be
recorded and played back.
• Fasten the strap firmly to your wrist to avoid dropping the camera.
3 Dry the camera by standing it on a
dry cloth in a well ventilated shaded
area.
• This unit incorporates drain design,
draining water in gaps in the camera
[ON/OFF] button and zoom button etc.
• Do not dry the camera with hot air from
dryer or similar. Waterproof performance
will deteriorate due to deformation.
4 Confirm that there are no water droplets, open the side door, and wipe
off any water droplets or sand left inside using a soft, dry cloth.
• Water droplets may adhere to the card or battery when the side door is opened
without thoroughly drying. Also, water may accumulate in the gap around the
card/battery slot or the terminal connector. Be sure to wipe any water off with a
soft, dry cloth.
• The water droplets may seep into the camera when the side door is closed while it
is still wet, causing condensation or failure.
DC-FT7-TS7EB-DVQX1515_eng.book 17 ページ ２０１８年５月１０日 木曜日 午後２時１分