User Manual/Mode d’emploi Wired Remote Control/Télécommande câblée CZ-RD516C-1 2-5, 10 Mode d’emploi Télécommande câblée 6-10 Français English User Manual Wired Remote Control F569672
Wired remote control d e c f g b h 1 a 4 3 2 5 6 7 9 8 Remote Control Display Remote Control Preparation a OPERATION LED b OFF INDICATOR • Press and hold for approximately 5 seconds to show 12-hour (am/pm) or 24-hour time indication. c OPERATION MODE SELECTION INDICATOR 1. Press d TIMER/CLOCK SETTING DISPLAY 2.
1 TO TURN ON OR OFF THE UNIT • Please be aware of the OFF indication on the remote control display to prevent the unit from starting/stopping improperly. 2 TO SET TEMPERATURE • Selection range: 60°F ~ 86°F. 3 TO SELECT OPERATION MODE AUTO mode - For your convenience • Unit selects operation mode during startup according to temperature setting and room temperature. HEAT mode - To enjoy warm air • Unit takes a while to warm up. The power indicator blinks during this operation.
To set the timer DAILY TIMER SETTING WEEKLY TIMER SETTING • To turn ON or OFF the unit at a preset time. • Daily timer and weekly timer could not be set at the same time. • Promotes energy saving by allowing you to set up to 6 programmes in any given day. 1 3 4 2 1 • Press once to change the display from Clock to Timer or vice-versa. • Press for more than 4 seconds to change the display from Daily Timer to Weekly Timer or vice-versa. 2 Select ON or OFF timer 1.
OPERATION DETAILS NOTE The timer setting will shown at wired remote control only but not at indoor unit’s TIMER indicator. • POWERFUL, QUIET operation setting could be operate according to wireless remote control. • When wired remote control is in operation, the timer setting from wireless remote control will be cancelled. Check Current Timer Programme Perform the step below to check the timer programme for a particular day. 1. Press TIMER 2. Press to enter timer mode. to enter day setting. 3.
Information/Informations importantes Federal Communications Commission Interference Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
Panasonic Corporation Website: http://panasonic.net/ Panasonic Canada Inc. Website/Site Web: http://www.panasonic.com For support: http://www.panasonic.ca/english/support Pour le soutien: http://panasonic.ca/french/support © Panasonic Corporation 2014 Printed in China Imprimé en Chine For inquiries (U.S.A.), please call 1-800-851-1235 (Pour les É.-U.
