Installation Manual

7. How to check overlapping of central address no.

(1) Press the and buttons at the same time for more than 4

seconds.

and CODE No. C1 will ﬂ ash.

(2) Select CODE. No. C3 by pressing

, ( ) button and

press the button.

C3 changes from ﬂ ashing to ON state and will ﬂ ash. Then

auto. overlap checking will start.

(3) If C3 changes from ON to ﬂ ashing and stops ﬂ ashing and

disappears, there is no overlapping.

Then ﬁ nally, complete the auto overlap checking mode by pressing

the button.

(4) If some of GROUP No., ZONE No. and UNIT No. ﬂ ash, you should

try again the zone registration.

① Select CODE No. C1 by pressing , ( ) button and

press the button.

② Select the ﬂ ashing GROUP No. with ZONE and GROUP button.

Then press the button and reselect the ZONE, GROUP and

UNIT No.

③ Then ﬁ nally, complete the auto. overlap checking mode by

pressing the button.

Fig. 13

CZ-64ESMC1U_eng.indd 17

2011/09/20 19:15:00