Installation Manual

1 IMPORTANT SAFETY INSTRUCTIONS
7
Caution
Use the special supplied touch pen
Touching the touch panel with any pen other than the
supplied touch pen can damage the system.
Moving and Repair Precautions
Warning
Do not disassemble or repair
Never disassemble or repair the
system yourself. Contact your
dealer for repair. Electric shock or
fi re may result if an inexperienced
person attempts to repair the
system.
Contact your dealer before moving
the system
Contact your dealer or a
professional service provider about
moving and reinstalling the system.
Electric shock or fi re may result if an
inexperienced person performs any
installation procedures
incorrectly.
Do not touch the LCD if it is leaking
If the touch panel is damaged, the liquid crystal from inside the display may leak out. Do not
ingest the liquid or allow it to contact your skin.
If accidental contact with skin occurs, rinse the area of contact thoroughly under running
water for at least 15 minutes.
If accidental swallowing occurs, rinse the inside of your mouth thoroughly with water. Drink
plenty of water and induce vomiting, and then seek immediate medical attention.
Prohibited
Prohibited
Contact
your dealer
Prohibited
Note: ●This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
●FCC Caution: To assure continued compliance, follow thw attached installation instructions.
Any changes or modifi cations not expressly approved by the party responsible for compliance could
void the user’s authority to operate this equipment.
CZ-256ESMC1U_改.indb 7CZ-256ESMC1U_改.indb 7 2011/11/11 11:24:592011/11/11 11:24:59