Installation Manual

30
6 USING THE SYSTEM
Main
Sub
5
5
5
5
6.3.6 Clear accumulation data
Use this screen to erase total data after test runs, and to restart total calculations for operating
time, operating counts, and so on.
Procedure
Select 5.Initial settings in the main menu and 5.Clear accum. data in the sub menu, then
proceed as follows.
1
1.Status/Control
2.Total data/Cut-off
3.Distrib. ratio/Usage
4.Maintenance/Test Run
5.Initial settings
6.Auxiliary settings
1.Date/Distrib.
2.CNTR/Unit/Ten. No.
3.Ten. name/Distrib. Gr.
4.Pulse meter setting
5.Clear accum. data
A
Touch Clear accum. data .
A window like the following appears.
1.60(160)
09.Mar.2011
Touch Yes . Total data up to now is erased, and
calculation of total operating time restarts.
CZ-256ESMC1U_改.indb 30CZ-256ESMC1U_改.indb 30 2011/11/11 11:25:202011/11/11 11:25:20