Datasheet

47
Arm Setting Position
The roller arm of the arm types
(AZD1003, AZD1004, AZD1008,
AZD1053, AZD1054 and AZD1058) can
be set in any position at 15° intervals.
Loosen the arm fastening hex. nut, repo-
sition the arm, and retighten the hex. nut.
When doing so tighten the hex. nut with
the arm secured to the unit. Tightening
without securing may cause damage.
Also, the same is true of the variable rod
types (AZD1007 and AZD1057).
Roller Direction
The roller of the arm types (AZD1004,
AZD1008, AZD1054 and AZD1058) can
be mounted on the front and rear (dotted
line in the figure) sides of the switch, as
shown below. (Positioned on the front
side at delivery.)
To set the roller on the rear side, remove
the arm fastening hex. nut, and reinsert
the arm so as to face the roller in the
rear direction. Then, retighten the hex.
nut.
Roller Lever Direction
AZD1000, AZD1009, AZD1050 and
AZD1059 type is move a detection object
in the D direction as shown below. Be
sure not to move the object oppositely.
If the opposite direction is required,
change the direction of the lever.
Hex. nut
Adjustable Arm Length
To adjust the length of the adjustable
arm of AZD1008 and AZD1058, slightly
loosen the arm fastening hex. nut, and
adjust the length.
The adjustable arm is graduated in two
kinds of length units. Use these indica-
tions as the reference during adjustment.
20
40
60
3
2
1
D
D
The roller lever can be set in two direc-
tions at 180° intervals. (Even though it
can be also set in the 90° direction, the
mounting surface will project.) Remove
the four lever base fastening screws,
turn the lever together with the lever
base in 180°, and retighten the four
screws at a torque of 0.20 to 0.39 N•m {2
to 4 kg•cm}.
Mounting side
Lever rest
Mounting s
Lever rest
Head Direction
The head of the arm types (AZD1003,
AZD1004, AZD1008, AZD1053,
AZD1054 and AZD1058) can be set in
any of four directions at 90° intervals, but
not in any other intermediate directions.
Loosen four screws on the upper side of
the head, and set the head in a desired
direction, and retighten them at a torque
of 0.20 to 0.39 N•m. Be careful not to
use too much strength when tightening
as this will cause the threads to strip.
Also, the same is true of the variable rod
types (AZD1007 and AZD1057).
Screw
DL (AZD1)
Conduit connector (PF type)
AZD1830
General tolerance: ±0.5 ±.020
11 dia.25 dia. 22
19
(
14
)
33
G.1/2
8
11 dia.
(
.551
)
.118 .118.315
.433.433.984
.748
.866
Rubber seal
inside diameter
9 dia. (.354)
Adaptable cable outer diameter
Min. Max.
7.5 dia. (.295) 9.5 dia. (.374)
11 dia. (.433) 9 dia. (.354) 11 dia. (.433)
mm inch
04/2005