Multi Purpose Camera Operating Instructions
Table Of Contents
- TABLE OF CONTENTS
- Accessories
- Introduction
- Characteristics
- Precautions for use
- Major operating controls and their functions
- How to install
- How to set up the system
- Configuration example 1: Connection of camera controller
- Configuration example 2: High-speed P/T system (1)
- Configuration example 3: High-speed P/T system (2)
- Configuration example 4: Controlling the camera from the AW-RP655 or AW-RP555 controller
- Control exercised from the AW-CB400.
- When the camera is to be controlled from the AW-RP655 controller
- When the camera is to be controlled from the AW-RP555 controller
- Cable wiring specifications when connecting the camera directly to the AW-CB400, AW-RP655 or AW‑RP555
- Operation procedure
- How to adjust
- Intelligent functions
- Setting of menu items
- Appearance
- Specifications
- 55 -
SETTING menu
[5] INTELLIGENT1
IRIS RANGE [1, 2, 3]
The iris control range during AGC operations
is selected using this menu item.
1: F1.8 to F8
2: F1.8 to F11
3: F1.8 to F16
When the iris cannot be adjusted within
the above range settings, use the gain
(including PIX MIX, V MIX, and FRAME
MIX), ND filter, and minus gain settings to
adjust the range so that the appropriate
level of exposure is achieved.
ATW AREA [25%, 50%, 90%]
The ATW white detection range is selected
here.
The range is set to an area that is
approximately 25 %, approximately 50 %,
or approximately 90 % of the horizontal
and vertical angles of view from the screen
center, respectively.
ATW SPEED [1 to 5]
The ATW convergence speed can be set to
any of 5 levels here.
The speed becomes faster as the figure
increases.
Setting of menu items