Multi Purpose Camera Operating Instructions
Table Of Contents
- TABLE OF CONTENTS
- Accessories
- Introduction
- Characteristics
- Precautions for use
- Major operating controls and their functions
- How to install
- How to set up the system
- Configuration example 1: Connection of camera controller
- Configuration example 2: High-speed P/T system (1)
- Configuration example 3: High-speed P/T system (2)
- Configuration example 4: Controlling the camera from the AW-RP655 or AW-RP555 controller
- Control exercised from the AW-CB400.
- When the camera is to be controlled from the AW-RP655 controller
- When the camera is to be controlled from the AW-RP555 controller
- Cable wiring specifications when connecting the camera directly to the AW-CB400, AW-RP655 or AW‑RP555
- Operation procedure
- How to adjust
- Intelligent functions
- Setting of menu items
- Appearance
- Specifications
- 53 -
SETTING menu
[5] INTELLIGENT1
INTELLIGENT MODE
[AGC, ATW, AGC+ATW]
The intelligent control setting is selected
using this menu item.
AGC: When the gain cannot be
adjusted within the IRIS
RANGE setting, gain control
(including PIX MIX, V MIX,
and FRAME MIX) and
automatic exposure control
performed by adjusting the
ND filter setting are executed.
ATW: When the subject is
identified as being white, the
white balance is adjusted
automatically.
AGC+ATW: The above AGC and ATW
adjustments are performed at
the same time.
ND FILTER SELECT
[CLEAR, 1/4, 1/16, 1/64, AUTO]
The ND filter setting during AGC operations
is selected using this menu item.
AUTO: Depending on the light quantity,
the ND filter is adjusted to the
appropriate position.
CLEAR, 1/4, 1/16, 1/64:
The specified ND filter setting is
fixed.
During AGC operations, control cannot be
exercised from the camera controller.
AGC SPEED [1 to 5]
The AGC convergence speed can be set to
any of 5 levels here.
The speed becomes faster as the figure
increases.
Setting of menu items