Multi Purpose Camera Operating Instructions
Table Of Contents
- TABLE OF CONTENTS
- Accessories
- Introduction
- Characteristics
- Precautions for use
- Major operating controls and their functions
- How to install
- How to set up the system
- Configuration example 1: Connection of camera controller
- Configuration example 2: High-speed P/T system (1)
- Configuration example 3: High-speed P/T system (2)
- Configuration example 4: Controlling the camera from the AW-RP655 or AW-RP555 controller
- Control exercised from the AW-CB400.
- When the camera is to be controlled from the AW-RP655 controller
- When the camera is to be controlled from the AW-RP555 controller
- Cable wiring specifications when connecting the camera directly to the AW-CB400, AW-RP655 or AW‑RP555
- Operation procedure
- How to adjust
- Intelligent functions
- Setting of menu items
- Appearance
- Specifications
- 50 -
SETTING menu
[4] PROTOCOL
PROTOCOL [1 to 4]
For selecting the remote control
communication system in accordance with
the system connected.
1: Information camera communication
protocol (EIA422)
For connecting the AK-HRP150G or
AK-HRP900
(With the AK-HRP900, this setting
cannot be used at a baud rate of
9600 bps.)
2: Information camera communication
protocol (EIA232)
For connecting a PC
(This setting cannot be used at a baud
rate of 9600 bps.)
3: Convertible PC control protocol
(EIA422)
For connecting the AW-CB400
(baud rate fixed at 9600 bps)
4: Convertible PC control protocol
(EIA232) For connecting the AW-PH400
pan/tilt head (baud rate fixed at
9600 bps)
The protocol is actually switched after the
power has been turned off and back on.
Setting of menu items