Multi Purpose Camera Operating Instructions
Table Of Contents
- TABLE OF CONTENTS
- Accessories
- Introduction
- Characteristics
- Precautions for use
- Major operating controls and their functions
- How to install
- How to set up the system
- Configuration example 1: Connection of camera controller
- Configuration example 2: High-speed P/T system (1)
- Configuration example 3: High-speed P/T system (2)
- Configuration example 4: Controlling the camera from the AW-RP655 or AW-RP555 controller
- Control exercised from the AW-CB400.
- When the camera is to be controlled from the AW-RP655 controller
- When the camera is to be controlled from the AW-RP555 controller
- Cable wiring specifications when connecting the camera directly to the AW-CB400, AW-RP655 or AW‑RP555
- Operation procedure
- How to adjust
- Intelligent functions
- Setting of menu items
- Appearance
- Specifications
- 12 -
Tally output connector [TALLY OUT]
The R tally and G tally signals are output from this connector.
Pin No. Signal
1 GND
2 R_TALLY_OUT
3 G_TALLY_OUT
4 +12 V (500 mA Max)
IRIS connector [IRIS]
Used to connect the IRIS control cables of the lens.
Pin No. Signal Pin No. Signal
1 Return control 7 Iris follow
2 VTR-S/S 8 Iris auto selection
3 UNREG GND 9 —
4 Iris manual selection 10 Zoom position information
5 Iris control 11 Focus position information
6 UNREG 12 V 12 NC
Zoom/Focus connector [ZOOM/FOCUS]
Used to connect the zoom/focus control cables of lens.
Pin No. Signal Pin No. Signal
1 Focus control selection 7 COM
2 Zoom control selection 8 Focus control
3 GND 9 Zoom control
4 Forcible iris closing 10 Iris control selection
5 Iris control 11 COM +Voltage
6 +Voltage 12 COM –Voltage
Optional card slot
Slot for inserting an optional card.
This product does not support the optional boards (AK-HHD1500G and
AK-HDC1500G).
Note
Major operating controls and their functions