User Manual

33
Setting the time data
Setting the time code
The various settings related to the time code are
performed using the following items on the
setting menu RECORDING SETUP screen.
OTCG item
OFIRST REC TC item
OTC PRESET item
O1394 TC REGEN item (appears in the VCR
mode)
For further details, refer to page 42.
OWhen ON has been selected as the setting
for the 1394 TC REGEN item in the VCR
mode, the settings of the items listed above
cannot be changed.
1
Set the camera recorder’s POWER switch to
ON.
2
Select PRESET as the setting for the FIRST
REC TC item on the setting menu
RECORDING SETUP screen.
OFor details on the menu operations, refer
to page 36.
3
Tilt the OPERATION lever in the 4 direction
and move to the TC PRESET item.
:
H
–––––––– YYEESS
UB MODE
H
USER
UB PRESET
H
––––
PUSH MENU TO RETURN
TTCC PPRREESSEETT
RECORDING SETUP
REC SPEED
H
SP
AUDIO REC
H
16bit
MIC GAIN1
H
–50dB
MIC GAIN2
H
–50dB
TCG
H
REC RUN
RREEGGEENN
H
PPRREESSEETT
;
PUSH MENU TO RETURN
FFIIRRSSTT RREECC TTCC
RECORDING SETUP
4
Press “;” of the OPERATION lever, and
move “1” to YES.
:
––––––––
H
YYEESS
UB MODE
H
USER
UB PRESET
H
––––
PUSH MENU TO RETURN
TTCC PPRREESSEETT
RECORDING SETUP
5
The screen shown below appears. Set the
time code value using the OPERATION
lever.
Tilt the OPERATION lever in the 3 or 4
direction, select the time code value, press
“;” of the OPERATION lever, and move to
the next digit.
OWhen the COUNTER RESET button is
pressed on the screen shown below, the
time code value is reset to zero.
0h00m00s00f
+ :PUSH PLAY
– :PUSH STOP
SEL:PUSH STILL
PUSH MENU TO RETURN
0
TC PRESET
PRESET OK?
–––
.
PUSH STILL
YES
NNOO
TC PRESET
6
Upon completion of the time code value
setting, press the MENU button. The screen
shown below appears. Tilt the OPERATION
lever in the 4 direction, select YES, and
press “;” of the OPERATION lever.
7
Press the MENU button twice to release the
menu mode.
How to select the TC PRESET item setting
When the time code at the start of the recording
is to be recorded using the value specified by
the user as its initial value, set the time code
value using the TC PRESET item.