Manual
• . . A e- o oe- o - II II " A •
Break off the tab to
prevent recording.
Record
Screw driver
To record again
Cover the hole
with cellophane tape.
i I] _ {,] i i i_l _.-.l--l!i,hi,,z,]i F_Z;I ;'_'Yi]i'lL1 I] _o,] [I
DECK can play back discs bearing any of the
following marks:
Logo Disc type
DVD-RAM (Version 1.1 of the
Video Recording Format a
,_% unified video recording
standard)
_ DVD (DVD-Video)
_.. DVD-R (DVD-Video formatted
,_% discs [finalized])
DVD-Audio
A_DIO
_ _'_}_ CD (CD-DA)
CD-R/CD-RW
_]_ _ •CD-DA format
_ •WMA/MP3/JPEG file and
finalized.*
Discs Played 8cm (3") or 12cm (5")]
*A process that allows play on compatible equipment.
Discs which cannot be played
• DVD with Region No. other than "1" or "ALL"
• PAL discs (the audio on DVD-Audio can be
played), DVD-ROM, DVD-RW, DVD+R,
DVD+RW, CD-ROM, CDV, CD-G, CVD, SVCD,
SACD, CD-TEXT, Divx Video Disc, Photo-CD
and Video CD
II]L"_ I: FTITtlIilT_j
• Do not use irregularly shaped discs (e.g. heart-
shaped), as these can damage the unit.
• It may not be possible to play CD-R, CD-RW,
DVD-R and DVD-RAM in all cases due to the
type of disc or condition of the recording.
6
DVD-RAM discs must meet the following conditions
for this unit to be able to play them.
• Non-cartridge discs
Type • Discs that can be removed from
12 cm (5") 9.4 GB (double-sided)
ICapacity and 4.7 GB (single-sided)
__ • 8 cm (3") 2.8 GB (double-sided)
Remove TYPE 2 and 4 discs from their cartridges
before use, then return them when you are finished.
Read the instructions for the disc carefully.
• Some parts of the disc, for example where one program
ends and another begins, may not play smoothly.
Handling precautions
• Sticking a label on the disc may impair DVD-R playback.
• Do not attach sticker to discs. (Do not use discs with
exposed adhesive from tape or left over peeled-off
stickers.)
• Only hold disc by edges as shown below. Fingerprints,
dirt and scratches can cause skipping and distortion.
• Do not write on label side of disc.
• Never use record cleaning
sprays, benzine, thinner,
static electricity prevention
liquids, or any other solvent.
X
• Do not try to close disc tray when disc is not
properly placed.
To clean disc surface
With a soft, darnp (water only) cloth, O
gently wipe frorn the center hole to the f_.._
outer edge as shown below. (Wiping in a _ _._
circular pattern will scratch the surface.)
• DVD-RAM, DVD-R : X
Clean only with the DVD-RAM disc
cleaner available. Never use cloths or
cleaners for CDs etc.
If disc is brought from a cold to a warm
environment, moisture may form on the disc
Wipe away moisture with a soft, dry, lint-free cloth
before using disc. (See above.)
Improper disc storage
Discs could be darnaged if stored or left in areas:
• exposed to direct sunlight.
• that are humid or dusty.
• near heat (i.e. heater, radiator, etc.).










