Manual

Connection
VCR/ _mlcorder IHi_Pd
D VD/VCR DECK TV
Front of DECK
VIOE01N2L-AUDI0LN2-R
O O O
(Audio/Video In Terminals
on the front of DECK are
available)
O Connect VIDEO OUT terminal on Playing VCR to VIDEO IN terminal on DECK.
To monitor the dubbing, also connect TV as shown.
(_) Connect "L" and "R" AUDIO OUT terminals on Playing VCR to "L" and "R"
AUDIO IN terminals on DECK.
In place of Playing VCR, you can use other equipment, such as a Camcorder.
Simply connect the unit's Audio/Video outputs to DECK.
I :{:;..;.]l.lliti !1 :t'_lli_l I] :[_ [ --
insert a pre-recorded tape, insert a blank tape with record tab,
1
2
Press INPUT to set DECK Input mode to
LINE for Video Input.
(See "Selecting the Input Mode" below.
3
4
Press PLAY, then PAUSE Press REC, then STILL/PAUSE
immediately to enter PLAY/PAUSE immediately to enter REC/PAUSE
mode. mode.
The operation of steps 4 and 5 must be done on the
playing and recording VCRs at the same time.
Press PLAY to start dubbing. Press STILL/PAUSE to start dubbing.
Playing VCR starts playback. DECK starts recording.
Press STOP to stop dubbing. Press STOP to stop dubbing.
• To Monitor Dubbing on TV
1 Turn TV on and tune to the Recording
VCR channel (CH 3 or CH 4).
2 If Auto VCR/TV (see p. 32) is set to
"OFF," press VCR/TV on the remote
for VCR mode.
• Selecting the Input Mode
Method 1: Press INPUT repeatedly.
ChannelNumber*-+LINE1*-+LINE2
Method 2: Press OH AIJV.
Display will change as below.
[,.----_14-_-24,._3 •
Press• / (CABLE)(TV)) Press•
k,_"_LINE24,._LINE14,._125 or 69_P-"/_,_
• LI" or L2" lights up on Multi Function Display
O. Dubbing tapes protected with Copy (about 4 seconds) when LINE1 or LINE2 is selected,
Guard will result in poor quality • LINE1: For rear audio/video connection.
recordings. LINE2: For front audio/video connection,
_Caution: .Unauthorized exchanging and/or copying of copyrighted recordings may be
copyright infringement.
*Please note that some tapes cannot be dubbed on DECK.
Also, it is not possible to dub DVD/CD to VHS tapes using DECK.
*When _ appears on the screen while a button is being operated, it means
that the corresponding operation is prohibited by DECK or the disc.
35