Manual

Search System
For each recording, an invisible index
mark is placed on the tape. A program
index and information are also included
for timer recordings, These marks are
used to access or scan recordings.
I r'_ 1'_ [,._
.......................................'
EX T _SEAROH
Press SEARCH*
to display SEARCH
in Stop or Ray
mode, and then
press NUMBER
keys to select
recording number.
• To calculate
number, see below.
Press FF/SLOW+
or REW/SLOW- on
the remote to start
search.
($_EK SEARCN
FORWARD SEARCH : FF
REVERSE SEARCH : REW
Play begins at
search end.
To search forward
or back 1 index,
press FF/SLOW+ or
REW/SLOW- on the
remote while
screen _eft is
displayed (10 sec.).
• To cancel, press
PLAY or _TOP.
[_1 [,."],'_,j
• To Calculate Index Number
Example 1:
To go to rec. 2 from rec. 4, enter 3 and press REW.
Example 2:
To go to rec. 6 from rec. 2, enter 4 and press FF.
NOTE: f indicates start points of each recording.
O
• if (ndex Search is started very close to air
index mark, that index mark may not be
counted in the search.
30
To quickly return to a specified tape location.
Press DISPLAY during play
to display Counter.
Press COUNTER
RESET on remote at
desired position to
reset to "0:00:00".
3 Continue to record, playback etc.
Press STOP,
_,_ :_oA_ o.o_ Press CM/ZERO
0:30:90
_ in Stop mode to start
Zero Search,
STOP 12:31AM CH 02
o:oo:oo
sp
• DECK will go into FF or REW mode and
stop at the last point the Counter was set
to 0:00:00.
DECK fast forwards (skips) over 1, 2, or 3
minutes of recorded tape as desired.
Press CM/ZERO in Play mode.
• The skip time can be changed by
pressing CM/ZERO repeatedly as shown
by the figure be_ow.
,.--.--q
PLAY
1st Press _1 rain Skip
!
2nd Press-----*2 min Skip
!
3rd Press---_3 rain Skip
• No indication appears on-screen,