Manual

AC Power Plug
• While plugged into an AC outlet,
this DECK consumes 0.85 W of
electrical power in off mode.
Bold: VCR Function Itafic: DVD Function
Bold ltafic: VCR and DVD Functions
VHF/UHF Antenna Output Terminal
p.12
VHF/UHF Antenna Input Terminal
p. 12
Video Output Video Input
Connector Connector
p. 12 p. 35
Optical Digital Audio
Output Connector
(DVD Only)
p. 15
Component Video Output
Connector (Y, P_, PR)
(DVD Only)
p. 13
Audio Output 1
Connector (L/R)
p. 12
S-Video Out Connector Audio Output2 Audio Input
(DVD Only) Connector (L/R) Connector (L/R)
pp. 10, 13 p. 13 p. 35
The following table shows the status of the output jacks when in VCR or DVD mode.
Video Output Component S- VIDEO OUTAudio Out 1 Video Output
Audio Out 2
VCR YES N/A N/A
DVD YES YES
Q• PROG functions on the remote are not available when using Component Video Output and
S-VIDEO OUT. Please set TV to either RF INPUT or VIDEO INPUT, and then press PROG.
,To enjoy PROGRESSIVE SCAN video
(1). Connect Component Video Output to the component video input terminals of a television.
(See p. 13.)
(2).When PROGRESSIVE OUT is set to "ON" in the DVD Main Menu (p. 55), a Progressive
Scan signal is output from the Component Video Output Connector.
Notes
• The screen may shift off-center when using progressive output. Please adjust the screen
position if this occurs. (Refer to your TV manual.)
• If the television is not progressive compatible, a progressive scan picture is not available.
Connect the Video Output or S-Video Output connector (see p. 12, 13) and
set PROGRESSIVE OUT to "OFF" in the DVD Main Menu. (See p. 55.)
10