Router User Manual

Nortel Secure Router 8000 Series
Troubleshooting - VAS 3 Firewall troubleshooting
Issue 01.01 (30 March 2009) Nortel Networks Inc. 3-7
Command Description
display traffic policy interface
[ { interface-type interface-number }
[ inbound | outbound | dlci
dlcinumber ]
Displays all policies applied on the synchronous
interfaces with FR (Frame Relay) as the link
layer protocol.
display this
[Nortel-Ethernet2/0/0] display this
#
interface Ethernet2/0/0
traffic-policy mypolicy1 inbound
#
return
Check that the policy is applied on the interface.
display this interface
[Nortel-Ethernet2/0/0] display this interface
Ethernet2/0/0 current state : UP
Line protocol current state : UP
Description : NORTEL, Nortel Series, Ethernet2/0/0 Interface
The Maximum Transmit Unit is 1500 bytes, Hold timer is 10(sec)
Internet Address is 4.1.1.1/24
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is 00e0-fc39-1ffe
Output queue : (Urgent queue : Size/Length/Discards) 0/50/0
Output queue : (Protocol queue : Size/Length/Discards) 0/1000/0
Output queue : (FIFO queuing : Size/Length/Discards) 0/75/0
negotiation auto , speed 100M , duplex full, loopback not set
……
display traffic policy user-defined
[Nortel] display traffic policy user-defined mypolicy1
User Defined Traffic Policy Information:
Policy: mypolicy1
Classifier: class1
Behavior: behavior1
Firewall
Table 3-1 Description of the output information of the display traffic policy command
Main field Description
User Defined Traffic Policy Information Information about the policy defined by the
user
Policy The name of the policy
Classifier The class of the policy