Digital Camera User Manual
Table Of Contents
- 1 Introduction
- 2 Installation
- 3 General Use
- 4 Control Panel
- 5 System Settings
- 5.1 General Settings
- 5.2 Menu Settings
- 5.3 Presentation Settings
- 5.4 Call Quality
- 5.5 Audio
- 5.6 Video
- 5.7 Security
- 5.8 Network
- 6 Peripheral Equipment
- 6.1 Interfaces
- 6.2 Document Camera
- 6.3 DVD / VCR
- 6.4 Additional Cameras
- 6.5 Additional Microphones
- 6.6 Stereo Speaker Kit
- 6.7 Telephone Add-On
- 6.8 Dual Monitor
- 6.9 XGA Monitors and Projectors
- 6.10 VESA Display Power Management
- 6.11 Digital Monitor Power Management
- 6.12 Extended Display Identification Data (EDID)
- 7 Appendices
- Appendix 1: Technical Specifications
- Appendix 2: Bandwidth Information for TANDBERG Endpoints
- Appendix 3: Environmental Considerations
- Appendix 4: Guidelines for Setting up Rooms for Video Meetings
- Appendix 5: Security
- Appendix 6: Using the File System
- Appendix 7: Web Interface
- Appendix 8: Connecting the System to PRI/T1
- Appendix 9: Connecting the System to the Switched 56 Network
- Appendix 10: Connecting the System to ISDN Using NT1 Network Adapters
- Appendix 11: TANDBERG Cameras
- Appendix 12: Remote Control (TRC3 / TRC4)
- Appendix 13: Cisco CallManager
- Appendix 14: Diagnostics Tools for IP
- Appendix 15: System Upgrade
- Appendix 16: Declaration of Conformity
- Appendix 17: Dimensions
- Appendix 18: Protocols Supported
- Appendix 19: Cable Specifications
- 8 Glossary
- 9 Index
TANDBERG Edge 75/85/95 MXP
82
Using an external MCU with limited Chair Control Support you may have the following
services
With an external MCU that does not support H.243, you have the following services:
Request/Release Floor
Terminal Names
* The MultiSIte option is not available on the TANDBERG 550 MXP, TANDBERG 770 MXP and TANDBERG 1000 MXP