Digital Camera User Manual
Table Of Contents
- 1 Introduction
- 2 Installation
- 3 General Use
- 4 Control Panel
- 5 System Settings
- 5.1 General Settings
- 5.2 Menu Settings
- 5.3 Presentation Settings
- 5.4 Call Quality
- 5.5 Audio
- 5.6 Video
- 5.7 Security
- 5.8 Network
- 6 Peripheral Equipment
- 6.1 Interfaces
- 6.2 Document Camera
- 6.3 DVD / VCR
- 6.4 Additional Cameras
- 6.5 Additional Microphones
- 6.6 Stereo Speaker Kit
- 6.7 Telephone Add-On
- 6.8 Dual Monitor
- 6.9 XGA Monitors and Projectors
- 6.10 VESA Display Power Management
- 6.11 Digital Monitor Power Management
- 6.12 Extended Display Identification Data (EDID)
- 7 Appendices
- Appendix 1: Technical Specifications
- Appendix 2: Bandwidth Information for TANDBERG Endpoints
- Appendix 3: Environmental Considerations
- Appendix 4: Guidelines for Setting up Rooms for Video Meetings
- Appendix 5: Security
- Appendix 6: Using the File System
- Appendix 7: Web Interface
- Appendix 8: Connecting the System to PRI/T1
- Appendix 9: Connecting the System to the Switched 56 Network
- Appendix 10: Connecting the System to ISDN Using NT1 Network Adapters
- Appendix 11: TANDBERG Cameras
- Appendix 12: Remote Control (TRC3 / TRC4)
- Appendix 13: Cisco CallManager
- Appendix 14: Diagnostics Tools for IP
- Appendix 15: System Upgrade
- Appendix 16: Declaration of Conformity
- Appendix 17: Dimensions
- Appendix 18: Protocols Supported
- Appendix 19: Cable Specifications
- 8 Glossary
- 9 Index
TANDBERG Edge 75/85/95 MXP
iv
Disclaimer
The information in this document is furnished for informational purposes only, is subject to
change without prior notice, and should not be construed as a commitment by TANDBERG. The
information in this document is believed to be accurate and reliable; however TANDBERG
assumes no responsibility or liability for any errors or inaccuracies that may appear in this
document, nor for any infringements of patents or other rights of third parties resulting from its
use. No license is granted under any patents or patent rights of TANDBERG.
This document was written by the Research and Development Department of TANDBERG,
Norway. We are committed to maintain a high level of quality in all our documentation. Towards
this effort, we welcome you to
Contact us with comments and suggestions regarding the content
and structure of this document.
Patent information
TANDBERG technology described in this manual is protected by one or more of the following
U.S. Patent No. 5,584,077 - 5,838,664 - 5,600,646 - 7,010,119 - 7,034,860 and other patents are
pending in the United States and/or other countries.
COPYRIGHT © 2005–2006, TANDBERG
snprintf
Copyright 1999, Mark Martinec. mark.martinec@ijs.si All rights reserved
Snprintf is distributed under the terms of the snprintf license, which is a Frontier Artistic style open source license.
A standard copy of snprintf can be located at the author’s web site: http://www.ijs.si/software/snprintf/
xSupplicant (wpa_supplicant) 802.1x
Copyright (c) 2002-2005, Jouni Malinen jkmaline@cc.hut.fi
xSupplicant is distributed under the terms of the xSupplicant license, which is a BSD style open source license.