Digital Camera User Manual
Table Of Contents
- 1 Introduction
- 2 Installation
- 3 General Use
- 4 Control Panel
- 5 System Settings
- 5.1 General Settings
- 5.2 Menu Settings
- 5.3 Presentation Settings
- 5.4 Call Quality
- 5.5 Audio
- 5.6 Video
- 5.7 Security
- 5.8 Network
- 6 Peripheral Equipment
- 6.1 Interfaces
- 6.2 Document Camera
- 6.3 DVD / VCR
- 6.4 Additional Cameras
- 6.5 Additional Microphones
- 6.6 Stereo Speaker Kit
- 6.7 Telephone Add-On
- 6.8 Dual Monitor
- 6.9 XGA Monitors and Projectors
- 6.10 VESA Display Power Management
- 6.11 Digital Monitor Power Management
- 6.12 Extended Display Identification Data (EDID)
- 7 Appendices
- Appendix 1: Technical Specifications
- Appendix 2: Bandwidth Information for TANDBERG Endpoints
- Appendix 3: Environmental Considerations
- Appendix 4: Guidelines for Setting up Rooms for Video Meetings
- Appendix 5: Security
- Appendix 6: Using the File System
- Appendix 7: Web Interface
- Appendix 8: Connecting the System to PRI/T1
- Appendix 9: Connecting the System to the Switched 56 Network
- Appendix 10: Connecting the System to ISDN Using NT1 Network Adapters
- Appendix 11: TANDBERG Cameras
- Appendix 12: Remote Control (TRC3 / TRC4)
- Appendix 13: Cisco CallManager
- Appendix 14: Diagnostics Tools for IP
- Appendix 15: System Upgrade
- Appendix 16: Declaration of Conformity
- Appendix 17: Dimensions
- Appendix 18: Protocols Supported
- Appendix 19: Cable Specifications
- 8 Glossary
- 9 Index
General Use
135
If you have no stored presets on your system, you are likely not to use presets. Therefore the
presets option is not present in the dialog box. Press arrow key to navigate in the list. Press OK
on the remote control to select the desired entry.
Press a number key while in a call, when having no
MultiSite and having stored presets:
A dialog box appears offering the options:
• Dial Extension Number -> Go to Touch Tones Mode
• Use Presets -> Go to Camera Presets mode
If you don’t have MultiSite (or you have used all your MultiSite capacity), the Add Call option is
not present in the dialog box. Press arrow key to navigate in the list. Press OK on the remote
control to select the desired entry.
Press a number key while in a call, when having no
MultiSite and no stored presets:
You go directly to Touch Tones Mode because no other options are available. In Touch Tones
Mode (DTMF) the user can dial extension numbers, access codes, passwords, etc.