Router User Manual
Table Of Contents
- Title Page
- Contents
- About This Document
- Overview
- Power Supply
- Heat Dissipation System
- Boards
- 4 Boards
- 4.1 Introduction
- 4.2 RPUs
- 4.3 NPUs
- 4.4 10/100Base-TX electrical interface module
- 4.5 100Base-FX Ethernet optical interface module
- 4.6 1000Base-X Ethernet optical interface module
- 4.7 Channelized and unchannelized E1/T1 interface module
- 4.8 Channelized E3 interface modules
- 4.9 Synchronous serial port module
- 4.10 Channelized and unchannelized POS optical interface modules
- 4.11 HSSI interface module
- 4.12 IPSec encryption HIC module
- 4 Boards
- Cables
- Appendix A List of Indicators
- Appendix B List of Boards
- B List of boards
- B.1 Boards
- B.2 RPU
- B.3 10/100Base-TX FE electrical interface module
- B.4 100Base-FX Ethernet optical interface module
- B.5 1000Base-X Ethernet optical interface module
- B.6 Channelized and unchannelized E1/T1 interface module
- B.7 Channelized E3 interface modules
- B.8 Synchronous serial port module
- B.9 ATM 155M optical interface module
- B.10 Channelized and unchannelized POS optical interface module
- B.11 HSSI interface module
- B.12 IPSec encryption HIC
- B List of boards
- Appendix C Acronyms and abbreviations
- Index
- Cover & Spine
4 Boards
Nortel Secure Router 8012
Hardware Description
4-18 Nortel Networks Inc. Issue 5.3 (6 April 2009)
z
encapsulates and decapsulates the data frame after high-speed interface control packets
enter the network process module
z
periodically detects the state of the network process module and queries the board
version
z
updates the Erasable Programmable Logic Device (EPLD) and FPGA, and implements
the online loop and offline loop of FPGA in the board
z
monitors the temperature
z
supports resetting of the service interface board and other main modules
z
supports the CABwatch debugging tool provided by IBM
4.3.2 Front panel
Figure 4-8 shows the appearance of the NPU front panel.
Figure 4-8 Appearance of the NPU front panel
RUN
A
L
M
Table 4-12 describes the NPU indicators.
Table 4-12 Description of the NPU indicators
Component Description
RUN (green) The running LED. Blinking means the NPU works normally. Constant
OFF means the NPU is not in position or failed.
ALM (red) The alarm LED. Constant ON means NPU failed.
The NPU does not provide external interfaces.
4.3.3 Technical specifications
Table 4-13 describes the NPU technical specifications.