User's Manual
Table Of Contents
FCC RF Exposure Information
This model phone meets the U.S. government's requirements for
exposure to radio waves.
Your wireless phone contains a radio transmitter and receiver. Your
phone is designed and manufactured not to exceed the emission limits
for exposure to radio frequency (RF) energy set by the Federal
Communications Commission of the U.S. Government. These limits are
part of comprehensive guidelines and establish permitted levels of RF
energy for the general population. The guidelines are based on
standards that were developed by independent scientific organizations
through periodic and thorough evaluation of scientific studies.
The exposure standard for wireless mobile phones employs a unit of
measurement known as the Specific Absorption Rate (SAR). The SAR
limit set by the FCC is 1.6 W/kg.
*
Tests for SAR are conducted using
standard operating positions accepted by the FCC with the phone
transmitting at its highest certified power level in all tested frequency
bands. Although the SAR is determined at the highest certified power
level, the actual SAR level of the phone while operating can be well
below the maximum value. This is because the phone is designed to
operate at multiple power levels so as to use only the power required
to reach the network. In general, the closer you are to a wireless base
station antenna, the lower the output.
Before a phone model is available for sale to the public, it must be
tested and certified to the FCC that it does not exceed the limit
established by the U.S. government-adopted requirement for safe
exposure. The tests are performed in various positions and locations
(for example, at the ear and worn on the body) as required by FCC for
each model. The highest SAR value for this model phone as reported
to the FCC when tested for use at the ear is 0.567 W/kg, and when
worn on the body in a holster or carry case, is 0.875 W/kg. (Body-worn
measurements differ among phone models, depending upon available
accessories and FCC requirements). While there may be differences
between the SAR levels of various phones and at various positions, they
all meet the U.S. government requirement.
The FCC has granted an Equipment Authorization for this model phone
with all reported SAR levels evaluated as in compliance with the FCC
RF exposure guidelines. SAR information on this model phone is on file
with the FCC and can be found under the Display Grant section at
http://www.fcc.gov/oet/ea/fccid/ after search on FCC ID
UCE212051A.
付録
90