User's Manual

European RF Exposure Information
This mobile phone complies with the EU requirements for
exposure to radio waves.
Your mobile phone is a radio transceiver, designed and
manufactured not to exceed the SAR
*
limits
**
for exposure
to radio-frequency (RF) energy, which SAR
*
value, when
tested
for compliance against the standard was 1.170 W/kg.
While there may be differences between the SAR
*
levels of
various phones and at various positions, they all meet
***
the
EU requirements for RF exposure.
*
The exposure standard for mobile phones employs a unit of
measurement known as the Specific Absorption Rate, or
SAR.
**
The SAR limit for mobile phones used by the public is 2.0
watts/kilogram (W/kg) averaged over ten grams of tissue,
recommended by The Council of the European Union. The
limit incorporates a substantial margin of safety to give
additional protection for the public and to account for any
variations in measurements.
***
Tests for SAR have been conducted using standard operating
positions
with the phone transmitting at its highest certified
power level in all tested frequency bands. Although the SAR
is determined at the highest certified power level, the actual
SAR level of the phone while operating can be well below the
maximum value. This is because the phone is designed to
operate at multiple power levels so as to use only the power
required to reach the network. In general, the closer you are
to a base station antenna, the lower the power output.
Declaration of Conformity
The product “P-01D” is declared to conform with the
essential requirements of European Union Directive
1999/5/EC Radio and Telecommunications Terminal
Equipment
Directive 3.1(a), 3.1(b) and 3.2. The Declaration
of Conformity can be found on
http://panasonic.net/pmc/support/index.html.
Concerning European Economic Area: The use of Wi-Fi is
restricted to only indoor use in France.
FCC Notice
• This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received,
including interference that may cause undesired
operation.
• Changes or modifications not expressly approved by the
manufacturer responsible for compliance could void the user’s
authority to operate the equipment.
その他
68