User's Manual

46 Phone/Network Services
1
Home screen W [Phone] W Enter receiver’s phone
number
Q If you enter wrong number, tap to clear the entered number.
2
3
To end the call, [End]
Emergency Call
Q This FOMA terminal supports “Emergency Location Report.”
When you make an emergency call such as at 110/119/118, information about
the place where you are dialing from (location information) is automatically
notified to emergency-response agencies such as police stations. It might
happen that your correct location is not detected by emergency-response
agencies depending on the location you dial from or radio wave conditions.
When your location information is notified, the name of emergency-response
agency is displayed on the Stand-by display. When you do not notify your
phone number such as by adding “184” by every call, your location information
and phone number are not notified. However, when an emergency-response
agency has judged that the location information and phone number should be
detected because of emergency priority such as for protection of human life, it
might get location information and phone number regardless of your setting.
Areas and timing “Emergency Location Report” introduced vary depending on
the preparation of respective emergency-response agencies.
Phone
Making Phone Call
Emergency call Phone number
Call to police 110
Call to fire station and ambulance 119
Call for accidents at sea 118
Q When you make a call at 110/119/118 from the FOMA terminal, tell an operator
that you are calling from a mobile phone and let them know your phone
number, and then clearly tell where you are currently around, so that police/fire
station can make a confirmation call to your mobile phone.
In addition, stay at the current location while talking preventing the call from
being disconnected. Do not turn off the power immediately, and make sure to
place your phone standby for at least 10 minutes after the call.
Q You might not be connected to regional police/fire station depending on the
area where you are calling from.
Selecting Whether Notify or Withhold Caller ID for Each
Call
Q Caller ID is valuable information of the customer. Please be thoughtful
about notifying/withholding it.
1
Home screen W [Phone] W Enter receiver’s phone
number
2
xA W [Set Notify caller ID active] (186 added)/
[Set Notify caller ID inactive] (184 added) W
Push Signal Input
Push signal is used for services such as home voicemail, ticket
reservation and bank balance check.
1
Home screen W [Phone] W Enter phone number
2
xA W [Add pause]
“,” is entered.
3
Enter push signal to transmit W
Push signal is automatically transmitted about 2 seconds after
connection is made.
Q If you select [Add wait] in Step 2, “;” is added and you may
transmit push signal manually. Transmission must be performed
after Step 3.
２０１１年５月１２日
午後１０時３４分