User's Manual

14
Introduction
Where it is used Material/Finishing
LUMIX
Phone panel
Body
ABS/aluminum foil + UV coating
Camera ring area (Inside) Aluminum/alumite treatment
Camera ring area (Middle) Acrylic urethane
Camera ring area (Outside)
※1
PC/UV coating
Camera ring area (Outside)
※2
PC/tin vapor deposition + UV
coating
Connector terminal side ABS/UV coating
Projection part of
connector terminal side
PC/aluminum vapor deposition
+ UV coating
Sheet of
battery
compartment surface
(large/small)
PET
Label PP
1Seg
antenna
Tip resin part PC/UV coating
Metal part (Pipe area),
Hinge area at bottom
part (Pin)
Stainless steel
Metal part (Wire area) Nickel
-
titanium alloy
Hinge area at bottom part
(Wire connection area)
Stainless steel/tin
-
cobalt
plating
Hinge area at bottom
part (Lift up area)
Brass/tin
-
cobalt plating
Holder area Zinc alloy/nickel plating
Compartment POM
microSD card
slot (inside
LUMIX Phone
panel)
Resin part LCP
Metal part Stainless steel/nickel plating
⿠Different materials may be used in some areas depending on the
body color.
※1 Body color “WHITE” “MAGENTA”
※2 Body color “BLACK”
Handling Precautions
General notes
Do not wet the equipment.
The FOMA terminal, battery, adapter, and UIM are not
waterproofed. Do not use them in environments, which are high
in humidity such as in bathrooms, and do not allow them to get
wet from rain. Furthermore, if carrying them against your body,
they become moist due to perspiration and the internal parts may
become corroded, causing malfunction. If the parts are found to
h
ave been damaged due to exposure to the liquids, any repairs
will not be covered by warranty, or repairs may not be possible.
This may be repaired at a cost if repairs are possible.
Use a dry soft cloth such as the one for cleaning glasses to
clean the equipment.
⿠
The display may be scratched if it is rubbed hard with a dry cloth.
⿠Stains may result from droplets of water or dirt if they are left
on the display.
⿠Do not use alcohol, thinner, benzene, detergent or other
solvents for cleaning, otherwise the printing may be removed
or discoloration may result.
Occasionally clean the terminals of the equipment using a dry
cotton swab, etc.
The soiled terminals deteriorate the connection and might cause
power discontinuity or incomplete charging. Wipe the terminals
with a cotton swab, etc.
Take care not t
o damage the terminals when cleaning them.
Do not place the FOMA terminal near an air conditioner outlets.
Condensation may form due to rapid changes in temperature,
and this may corrode internal parts and cause malfunction.
Do not apply excessive force onto the FOMA terminal and
battery pack.
If you put the FOMA terminal in a bag along with many other
articles or sit with the FOMA terminal in a clothes pocket, the
d
isplay, internal circuitry and the battery pack could be damaged
or malfunction. Also, if an external device is left connected to
the connector terminal (earphone/microphone terminal), the
connector could be damaged, or malfunction.