User's Manual

16
Introduction
Opening/Closing the
Connector Te
rminal Cover
■Opening the connector terminal cover
① Hook your finger
over the gro
ove,
pull out the cover
to dire
ction A,
and ro
tate it as
dire
ction B.
■Closing the connector terminal cover
①
Align the connector terminal cover in
parallel with the FOMA terminal, and while
holding its base part firmly,
push it into
place.
② Ensure that no float is found with the
connector terminal cover as a whole.
Removing/Attaching the
Back
Cover
■Removing the back cover
① Using the “
” part of the FOMA
terminal, lift up in the direction of the
arro
w to remove the back cover.
⿠Remov
ing the back cover might produce
a sound.
⿠The back
cover should be firmly
closed fo
r maintaining waterproofness/
dust
-
pro
ofness. Opening the cover
fo
rcibly may injure your nails or fingers.
■Attaching the back cover
① F
it the claws at the bottom side of the
back cover to the FOMA terminal secure
ly
(A), and fit the claws at the left, right and
upper sides of the back cover into the
corre
sponding indentations, and push the
cover into place (B).
Claw (left, right, and
upper)
Packing
Rear surface of back cover
Claw (bottom)
②Push the 10 ○ marks printed on the
sticker of the back cover,
and ensure that
no float is found anywhere
on the cover.
③ C
onfirm there is no gap between the back
cover and the FOMA terminal.
Base part
Hook