User's Manual

21
Introduction
Removing/Attaching the Back Cover
■Removing the back cover
① While pushing down on the area
ar
ound the f mark in direction A,
slide the back cover (by 2 mm or
mor
e) in direction B to disengage
and r
emove the cover.
②
Using the projections on the
inner
cover, pull up the inner cover in the
dir
ection shown by the arrow and
open it until it will go no further
.
⿠The inner cover should be
fir
mly closed for maintaining
w
aterproofness. Opening the cover
f
orcibly may injure your nails or
fingers.
■Attaching the back cover
①
Fit the claws at the left, right and bottom sides of the inner cover
i
nto the corresponding indentations, and push the cover into place.
Claw
Packing
Rear surface of inner cover
② Push the eight ● marks printed on the
sticker of the inner cover, and ensur
e
that no float is found anywhere on the
cover
.
③ With the back cover stayed open
about 2 mm, match it to the groove
on the FOMA terminal. Then while
pushing the back cover as a whole
downwar
d, slide it in the direction of
the arr
ow, and then install.
④
Confirm there is no gap between the back cover and the FOMA
terminal.
Caution
■About FOMA terminal
⿠Do not wash the FOMA terminal with a washing machine or ultrasonic
cleaner
.
⿠Never charge the battery when it gets wet.
⿠Do not lea
ve the FOMA ter
minal with drops of water remained on.
・ The connector terminal might be shor
t
-
circuited.
・ Water might enter into the inside of the FOMA terminal through
the k
eys or hinges. In cold districts, drops of water on the FOMA
ter
minal might freeze, resulting in malfunction.
If the FOMA ter
minal gets w
et, keep the back cover attached and the
connector terminal cover closed, drain off the water (see page 22), and
immediately wipe off the moistur
e r
emaining on the FOMA terminal
with a clean dry cloth.
⿠Do not drop the FOMA terminal nor give a shock to it.
The deter
ioration of the waterproof performance might result
depending on the damage.
⿠Do not soak the FOMA ter
minal in hot w
ater, use in a sauna, nor
expose to hot wind currents such as those of a dryer.
⿠The FOMA ter
minal does not float on w
ater.
⿠Do not directly expose to the strong water flows that exceed the
standar
d (see page 19) or submerge the mobile phone in water.
⿠Do not dir
ectly place the FOMA terminal on sandy beaches.
･
Sands enter into the holes on the microphone, earpiece, or
speak
ers may reduce the volume.
･
If you operate the FOMA terminal with water drops or sands
adher
ed to, sound might be deteriorated.
･
Even the slightest sands entered from the connector terminal cover,
inner co
ver or back cover could cause water to enter the inside of
the FOMA ter
minal.
Projection
Approx. 2 mm