User's Manual

15
Introduction
List of materials used
Where it is used Material/Finishing
Outer casing D
isplay surface PC/hard coating
Numeric key
surface,
Display side surface,
Bottom part of
display
panel,
Display back surface
※1
PC + UV coating
Display back surface
※2
PC/tin vapor deposition +
UV coating
B
attery surface
(
hinge side)
ABS/UV coating
Back cover P
C + ABS/UV coating
Connector terminal S
tainless steel/
nickel plating + tin plating
Connector
t
erminal
Cover PC, elastomer/UV coating
Packing Silicon rubber
Camera lens area P
MMA/hard coating
Side key PC/aluminum vapor deposition
+ UV coating
A
round the side key A
BS/UV coating
Charging terminal B
rass/nickel plating +
nickel palladium plating +
gold plating
Decorative area
(Display back surface
side)
※2
Crystal grass
Numeric key
s
urface
Key area,
Open/close stopper
Acrylic urethane
Sheet area PET
Where it is used Material/Finishing
Touch pen Body, Cap ABS
Inside of cap, pen tip P
OM
Strap band Polyester
Call/Charging indicator
(Display back surface side)
Crystal grass
Ring around t
he Call/Charging
indicator (display back surface side)
PC/tin vapor deposition +
UV coating
Corner area at the bottom part of the
d
isplay
Elastomer
Display panel G
rass/PET sheet
Tape (side surfaces of the battery
c
ompartment)
PET
Battery compartment surface S
tainless steel/nickel plating
Battery
t
erminal
Resin part PA
Terminal area Titanium copper/
n
ickel plating + gold plating
Battery pack R
esin area PC
Label PET
Terminal area Glass epoxy substrate/
nickel plating + gold plating
UIM tray P
OM
Hinge area Center PA/UV coating
D
isplay back surface
s
ide
ABS/UV coating
Hinge support area PC
Cap PET resin
F
lash part PMMA/hard coating
L
abel (inside of t
he inner cover) PET
Label (outside of t
he inner cover) PEN