Owner Manual

PRODUCT DIAGRAM
Chain
Heater
Cover
Heater Mesh
Element
Pull Switch
OPERATING INSTRUCTIONS
A..Place the heater on a firm, level ceiling surface;
B.The Hook on the ceiling hanging the Patio Heater must be able to undertake a weight 3 or 4 times
that of the Patio Heater itself.
C.Place the Hook around the Ceiling Hook and clip on any Ring of the Chain to adjust the height
of the Patio Heater to the Floor.
D.The distance between the bottom of the Patio Heater to the Floor must be over 1.8m, and the
distance between heater and ceiling must be at least 30cm.
E.
These appliances must be supplied with proper voltage and frequency (AC120V, 60Hz), and
connected to an individual, properly grounded branch circuit, protected by a circuit breaker which
in accordance with wiring ruls. power cord of this appliance must be fastened with the chain,
installation can only be carried out by qualified person in order to avoid a hazard.
F.Only operate the heater when it is in the upright position.Our Electric Patio Heater is equipped
with One heat settings The switch on the heater head is used to control the One heat setting.
For1500W, The 0 position is off. To operate the heater on high, push the Switch Cord again.
This will cause both the bottom and top heating elements to glow and radiate heat.
MAINTENANCE
Turn off the circuit breaker before maintenance and let the unit cool completely.
• To keep the heater clean, the outer shell may be cleaned with a soft, damp cloth. You may
use a mild detergent if necessary. After cleaning, dry the unit with a soft cloth.
• DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to clean
the heater. This may cause damage or deterioration to the surface of the heater.
• Although this heater is outdoor approved(Balconies and patios), DO NOT immerse the heater
in water for your safety. Wait until the unit is completely dry before use.
STORAGE
If the heater will not be used for a long period of time, store it in a cool, dry