BEFORE FIRST USE: To prevent any Internal damage. i Is very Important to keep refrigeration units (like this one) upright throughout their journey. Please leave tt stanching upright and outside the box for 24 HOURS before plugging It In. In the event this product malfunctions or customer believes Its defective, the customer should contact Customer Service and retain the defective product pending further instructions.
Congratulations on bringing home your new appliance! GENERAL INFO & SAFETY INSTRUCTIONS Read this manual thoroughly before first use, even If you are familiar with this type of product. The safety precautions enclosed herein reduce the risk of fire, electric shock and Injury when correctly adhered to, Keep the manual In a safe place for future reference, along with purchase receipt and carton. If applicable, pass these instructions on to the next owner of the appliance.
TABLE OF CONTENTS SAFETY PRECAUTIONS 4 INSTALLATION 5 APPLICATION & OPERATIVE 67 TEMP CONTROL/GENERAL OPERATION 8.
SAFETY PRECAUTIONS ELECTRICAL SAFETY & CORD HANDLING. « Correct voltage: Marks sure your local outs voltage and circuit frequency corresponds to the voltage Indicated on the appliance rating label. NOTE: Intended use: This ls a portable product, designed for private use. It Is exclusively designed for use In cars, caravans and other vehicles including mobile homes, camper vans, rail cars and boats. It is designed io coal food and beverages and to be set up in dry, weather protected arches.
INSTALLATION ASSEMBLY AND PARTS No. | Name 1 | Door Lock 2 | Freezer Zone 3 | Fridge Zone 4 | Control panel 5 | LED Inner Light 6 | Radiator Cover After unpacking the Fridge/Freezer check that no parts are missing. Place the unit In a dry place which Is protected against splashing water. Do not place directly adjacent to sources of heat such as heating, gas ovens, hot water, pipes or under the blazing sun.
APPLICATION & OPERATIVE OPERATING YOUR FRIDGE/FREEZER POWER REQUIREMENTS The Antifreeze is designed to operate voltage: © AC input 110-240V AC at 50Hz to ac adapter (a g. electrical power point} © DC input 12V or 24V DC (e.g.
APPLICATION & OPERATIVE OPERATING WITH 110~240V AC Plug the 110V-240V AC power adapter & cable into the Fridge power socks on the end of the Fridge/Freezer and then connect to a suitable 110V-240V AC power source Ths Fridge/Freszer will automatically tum on, there Is no requirement to switch the appliance on. Ths display wil automatically show the current Internal cabinet temperature.
TEMP CONTROL/GENERAL OPERATION When your Fridge/Freezer I first connected to the AC or DC power Input the appliance will automatically switch on and the LCD control panel wil display the current cabinet temperature, battery monitor and Eco setting as well as the current input voltage. » The Temperature Controller provides the ability to set the desired temperature level and display the current cabinet temperature. The electronics controller has banes programmed to maintain an average of the set temperature.
TEMP CONTROL/GENERAL OPERATION BATTERY MONITOR SETTING 1 Adjust the setting by pressing the Battery Protection button until desired setting is highlighted on display 12V DC input Cut out Cut in LOW 85V 10.9v MEDIUM 10. 11.4v HIGH nv 12.4v 24V DC input Cut out Cut in LOW 213V 22.7v MEDIUM 22.3V 23.7v HIGH 24.3V 25.7V “Values are for reference only and may be subject to change depending on conditions and power supply.
TIPS & MAINTENANCE TIPS AND SUGGESTIONS + Fresh and frozen foods should not be stored right beside sate other in the cabinet. Doing so may cause a fresh found to freeze and/or slop. = When ths appliance Is being set at 32'For lower temperatures, do not store glass hotties or liquids such as beer, milk, Simulcast or soft drinks In the unit as theses may freeze and shatter, leak or burst.
TROUBLESHOOTING Possible Solutions The Fridge/Freezer will not turn on Check the unit is switched ON Press the power button to turn on Check the power source (voltage may be too low) Check the power cable and all connections from the power source to Fridge/Freezer The contents of the fridge are freezing setting The temperature has been set too low, therefore increase the temperature setting.
TROUBLESHOOTING The display shows an error message Connected to DC power source, the Fridge/Freezer has switched off. This may be due to low voltage. Check Battery Monitor setting is on LOW, Fy Re-start vehicle to increase battery voltage level. Test and charge battery and the Fridge/Freezer do not cool The Fridge/Freezer has switched off due to an Internal fault.
SPECIFICATION Model CF-55 Capacity: 55L/59qt Cooling performance: A pe! DC FUSE (A) 15A RATED CURRENT FOR DC(A) NW 14 8kg Unit Dimension 690+345+524mm mm: 2717+13 Climatic Category T/ST/N/SN Protective Classification of | Electric Shock Resistance Refrigerant (g) 40g
WARRANTY Euhomy™ offers a limited one-year warranty {warranty period”) an all of our products purchased new and unused from Hormone Technologies, with an original proof of purchase amid where a defect has arisen, wholly or substantially, as a result of faulty manufacture, parts or workmanship during the warranty period.
OPERATING PANEL & APP USB port Is not equipped for all modes. @APP control Is not equipped for all modes. @Bully In battery Is equipped for Internal battery type. ® Product features are subject to real purchase. APP Connecting Operation: Download APP from App store or Google Play, “Car fridge freezer” then open the Bluetooth and APP, search the equipment, choose the fridge and there will be AP shown on the fridge display panel. Press setting button “setting” to connect mobile and fridge.
