PW237SFR 237 Litre Refrigerator
Contents 1. SAFETY WARNINGS ............................................................................................................ 1 2. INSTALLTION ...................................................................................................................... 2 2.1 Location ...................................................................................................................... 2 2.2 Reversing the Door Swing ....................................................................
2. INSTALLTION 2.1 Location When selecting a position for your unit you should make sure the floor is flat and firm, and the room is well ventilated. Avoid locating your unit near a heat source, e.g. cooker, boiler or radiator. Also avoid direct sunlight as it may increase the electrical consumption. Extreme cold ambient temperatures may also cause the unit not to perform properly. This unit is not designed for use in a garage or outdoor installation. Do not drape the unit with any covering.
3) Remove the hinge shaft sleeve and the door block to the other side. A. Remove the nut with sleeve. Take off the washer then remove the axes to the other side and fixed.
4) Disassemble the screws fixed the bottom hinge assembly with cross slot screwdriver and remove the adjustable foot Note：the refrigerator-freezer incline angle less 45°. 5) Replace the bottom hinge to the other side then fix it with screws.
) Install the left top hinge cover on the right and Remove the two screws 8) Install the top-hinge. set the top door right position, fix the top-hinge and the cover.
2.3 Door Space Requirements D The unit's door must be able to open fully as shown. W×D≥902×1052mm W 2.4 Levelling the Unit To do this adjusts the two levelling feet at the front of the unit. If the unit is not level, the door and magnetic seal alignments will not be covered properly. Make sure that the foot touches the ground before use. Look down from the top, clockwise and counterclockwise loosening, tightening. 2.
Before Plugging in You must check that you have a socket which is compatible with the plug supplied with the unit. ◆ Before Turning On! Do not turn on until two hours after moving the unit. 2.7 Interior Accessories Various glass or plastic storage shelves are included with your appliance - different models have different combinations. You should always slide one of the full size glass storage shelves into the lowest set of guides, above the fruit and vegetable containers, and keep it in this position.
4. OPERATION 4.1 Switching On Your Unit ◆The temperature selector knob is located on the right hand sidewall of the refrigerator interior Setting“Min” ：Less Cool Temperature Setting“Med” ：Normal Operation (adequate for most situations) Setting“Max” ：Coolest Temperature ◆During high ambient temperatures e.g. on hot summer days. It may be necessary to set the thermostat to the Coolest setting (position“Max”).
sure that thedoor is closed to avoid the polish getting on the magnetic door seal or inside the unit. ◆ The grille of the condenser at the back of the unit and the adjacent components can be vacuumed using asoft brush attachment. 5.2 Cleaning Tips Condensation may appear on the outside of the unit. This may be due to a change in room temperature. Wipe ofany moisture residue. If the problem continues, please contact a qualified technician for assistance. 6. MAINTENANCE 6.
be properlyclosed. Loud noises Too much food; Tilt refrigerator. Whether the food is leveled, whether the refrigerator is balanced; Whether the refrigerator parts are properly placed. 7.1 Warm tips: ◆The refrigerator enclosure may emit heat during operation specially in summer, this is caused by the radiation of the condenser, and it is a normal phenomenon.
on the back of the unit are damaged prior to disposal. Up to date informa on concerning op ons of disposing of your old unit and packaging from the new one can be obtained from your local council office. When disposing of an old unit break of any old locks or latches and remove the door as a safeguard. Correct Disposal of this product Correct Disposal of this product This marking indicates that this product should not be disposed with other household wastes throughout the EU.
Palsonic Customer Service Telephone (Australia) 1300 657 888 Palsonic Corporation Pty Ltd ABN 34 000 474 108 1 Joynton Avenue, Waterloo NSW 2017 Australia Telephone (02) 9313 7111 Facsimile (02) 9697 0655 www.palsonic.com.
