Operating instructions

11
5. Position the jug on the top base of the main body.
6. Turn the control to the “I” setting. The blue light framing the control switch will light up.
7. Theblenderhasthefollowingfunctions:“SMOOTHIE,“ICE”,“TURBO”.Pressoneofthe
buttons and that button will light up and the appliance will start operating.
8. To select the speed, put the control between “MIN” (minimum speed) and “MÁX”
(maximum speed) to select the desired speed.
9. Usetheappliancefornomorethan2minutesatonetime,andwait1minutebeforeusing
it again.
Caution:
1. Theblenderwillnotworkifthejugistoofull.Ifthisoccurs,turnofftheapplianceanddo
not plug it in. Remove some of the contents and then turn it on again.
2. Usetheappliancefornomorethan2minutesatonetime,andwait1minutebeforeusing
it again.
CLEANING AND MAINTENANCE
- Inadditiontoreadingtheseinstructions,readthesafetyprecautions.
- Donotwashthemotor,themainbody,cableorplugwithwater.
- Cleanthemotorbasewithasoft,dampclothandamilddetergent.
- Half fill the jug with hot water and a little detergent. Turn on the blender at maximum
speed until the jug is clean.
- The base and blades can be dismantled. Unscrew the base by turning it in an anti-
clockwise direction. Remove the blades and the rubber seal by pulling them upwards.
- Thenwashthejug,closingdevice,baseandbladeswiththerubbersealinhotwaterand
detergent. Dry all the parts well before replacing them. CAUTION! The blades in the jug
are very sharp.
- Do not use aggressive detergents.
Warning:
Donottouchtheblades;theyaresharp.Aftercleaning,wipewithadryclothtoavoidinjury.
ENVIRONMENTAL PROTECTION
Unwanted electrical products must not be disposed of with household waste. Take this
appliance to your local recycling centre for safe disposal.
Thank you for confiding in us by choosing one of our products.