assembly instructions

Please read these instructions carefully before you start to assemble this
product and carry out the steps in the order set out in these instructions.
When encountering the information icon, please refer to the relevant
assembly step for additional comments and assistance.
Care and Safety Advice
For safety purposes we strongly recommend the product to be assembled
by at least two people.
Some parts may have sharp edges. Please be careful when handling components.
Always wear gloves, eye protection, and long sleeves when assembling or performing
any maintenance on your product.
Do not attempt to assemble the product in windy or wet conditions.
Dispose of all plastic bags safely - keep them out of reach of small children.
Keep children away from the assembly area.
Do not attempt to assemble the product if you are tired, have taken drugs,
medications or alcohol, or if you are prone to dizzy spells.
When using a stepladder or power tools, make sure you follow the manufacturer's
safety advice.
Do not climb or stand on the roof.
Heavy articles should not be leaned against the poles.
Do not hang or lay on the profiles.
Keep roof and gutter clear of snow, dirt & leaves.
Heavy snow load on roof can damage the product, making it unsafe to stand
below or nearby.
Keep these instructions in a safe place for future reference.
If color was scratched during assembly it can be fixed.
Cleaning
Instructions
When your product needs cleaning, use a mild detergent solution and rinse with cold
clean water.
Do not use acetone, abrasive cleaners, or others special detergents to clean the panels.
Before Assembly
Choose your site carefully before beginning assembly.
Sort the parts and check according to the content parts list.
Please consult your local authorities if any permits are required prior to constructing
the product.
Tools & Equiph.ent
T001 (Supplied)
motes During Assembly
When encountering these icons, you are requested to either
keep the screws slightly loose or to fully tighten the screws.
Steps
_t
Step 1: The ground surface must be perfectly flat and leveled and have a solid base such
as concrete, deck etc. At this stage a circle should be marked for the hexagon corners to be
placed later.
Step 7: Attach the hexagon's corners to the marked circle, make sure they are flat and level
prior to connecting to the base. Make sure you use the suitable screws and plugs for your type
of base.
Step 17: If you find it slightly difficult to slide the roof panels in, it will be easily done by 2
people. One on a step ladder near the peak and the other pushing from the bottom.
Step 19: Please decide upon the entrance direction.The next assembly steps will show doors
with the locking done from outside (later on, we will show the assembly of the other doors
which are to be locked from inside)
* Please note, the direction and placement of the doors in the following steps
Step 26: Please assemble the rest of the doors, pay close attention to the direction.The
locking of the doors should be done from inside.
Please note:
Anchoring this product to the ground is essential to its stability and rigidity, and required in
order for your warranty to be valid.