Instructions / Assembly

EN
Steps
Note:
The wall anchoring kit supplied with this product is suitable only for concrete walls.
Other wall types need an accordant wall xation kit.
82787_L_18.10_MV_2-7
Notes During Assembly
0-54cm
0”-21
¼”
0-54cm
0”-21
¼”
A
B1
B2
13
º
17
º
C
226-286cm
89” - 112.5”
260-305cm
102.4”-120”
5-54cm
2”-21.6”
5-54cm
2”-21.6”
•
Use a soft platform below the parts to avoid scratches and damages.
•
Please note you install the panels with the UV protected side out (marked with “THIS SIDE OUT”)
remove plastic lm before inserting panels and locking in place.
•
Product dimensions can be adjusted to your specic needs:
1. The wall-mounting prole (top-back) can be adjusted from 260 to 305 cm (102.4” to 120”) above ground.
The adjusting is done when measuring and drilling (Step 5).
Please note the installation recommendations’ height suggested in Diagram A.
It is possible to x the Patio Cover back wall height at the lowest point of 260 cm/102.4”. This method is optional if the
assembly conditions and exterior walls do not allow to follow the suggested installation as appears in the manual.
Please note that the product appearance may slightly change as a result, however snow load weight does not change.
2. Poles distance from the wall can be adjusted from 226 to 286 cm (89” to 112.6”) as suggested in Diagram B1.
Poles distance from the side edges can be adjusted from 5 to 54 cm (2” to 21.6”) as suggested in Diagram B2.
The adjusting is done after assembly and before anchoring (Step 22) by sliding poles and prole 7030+7031 at the roof
proles’ channels.
3. Wall mounting and distance from the wall determine the roof angle and the total depth of the product (distance of
gutter from the wall). Higher wall mounting and shorter distance between wall and poles increase the roof angle and
shorten the total depth as suggested in Diagram C.
Step 5: It is important to plan the installation area, mark as per the instructions and level the surface prior to the
assembly. Make sure you use suitable screws and anchors.
Step 11: Apply silicone sealants above beam 7288 + 7289, in order to prevent water from seeping in.
Step 13: Make sure that the angle between the back wall prole and the panel supporting proles is 90 degrees.
Step 15: Please note you install the panels with the UV protected side out (marked with “THIS SIDE OUT”)
remove plastic sticker as panels are locked in place.
Step 19b: Apply silicone sealants on both sides of the part combining 8080 & 8079 in order to prevent water
leakage, as shown at the drawing 19b.
Step 20a: Apply silicone sealants on the inner part of 7997, and connect to the prole as depicted in drawing 20a.
Step 20c: Do not tighten screw 4043 yet, in order to allow the nal adjustments done in step 22b.
Step 22a+22c: Please adjust the poles (inside out and sideways) by sliding them to their nal position prior to
anchoring. Make sure that the poles distance from the Patio cover side edge does not exceed 54 cm/21.3”.
Step 22b: Adjust the gutter head’s angle according to your needs and tighten screws 4043.
Step 24: Anchoring this product to the ground is essential to its stability and rigidity. It is required to complete
this stage in order for your warranty to be valid.
* Tighten all screws when completing assembly.