Replacement Part List

IMPORTANT

Please read these instructions carefully before you start to assemble this shelf.

Please carry out the steps in the order set out in these instructions.

Keep these instructions in a safe place for future reference.

Tools & Equipment

supplied)

Care and Safety Advice

Some parts may have sharp edges. Please be careful when handling components.

Dispose of all plastic bags safely - keep them out of reach of small children.

Keep children away from the assembly area.

Before Assembly

Sort the parts and check according to the contents parts list.

Cutting the panels and profiles in only needed when installing the shelves from

the corner or installing 3 or more shelves side by side.

When installing the shelves side by side, some parts may be surplus.

Steps

Step 1: Installation varies between sheds, if you haven't inserted the screws for shelves installation in advance: disassemble the part in

accordance with the drawing in step 1, insert the screws, re-assemble and re-tighten.

(If you plan to install the shelves from the corner, for the Yukon Shed only, check step 12 for inserting the screws to the corner profile).

Step 3: Please note you should bend only profile #8917. Do not bend profile #8916!

Step 8: This step is for installing a single shelf and is compatible with all Palram sheds, the rear profile will reach the brackets' end or

surpass it, depending on the shed.

Step 9: This step is for installing 2 shelves side by side, the profiles should be attached in the middle of the central bracket, the ends will

pertrude.

Step 12: From this step onwards, there are instructions to install the shelf from the corner, possible only with the Yukon sheds.

Step 15 + 16: Make sure you plan and mark prior to cutting.

Step 20: Optional - it is possible to install the shelves along the entire wall, you may have to cut the panel and profiles in half.