Instructions / Assembly

A
IMPORTANT
You must build the Palermo Gazebo before you attached the Ledro walls.
Before beginning please refer to the Assembly Manual in the Palermo Gazebo carton.
Please read these instructions carefully before you start to assemble this product.
Please carry out the steps in the order set out in these instructions.
Keep these instructions in a safe place for future reference.
MWhen encountering the information icon, please refer to the relevant
assembly step for additional comments and assistance.
Cara and Spfatu Ar luir
For safety purposes we strongly recommend the product to be assembled
by at least two people.
Some parts may have sharp edges. Please be careful when handling components.
Always wear gloves, eye protection, and long sleeves when assembling or performing
any maintenance on your product.
Do not attempt to assemble the product in windy or wet conditions.
Dispose of all plastic bags safely - keep them out of reach of small children.
Keep children away from the assembly area.
Do not attempt to assemble the product if you are tired, have taken drugs,
medications or alcohol, or if you are prone to dizzy spells.
When using a stepladder or power tools, make sure you follow the manufacturer's
safety advice.
Do not climb or stand on the roof.
Heavy articles should not be leaned against the poles.
Do not hang or lay on the profiles.
Keep roof and gutter clear of snow, dirt & leaves.
Heavy snow load on roof can damage the product, making it unsafe to stand
below or nearby.
If color was scratched during assembly it can be fixed.
riclaninq Instructiorc
When your product needs cleaning, use a mild detergent solution and rinse with cold
clean water.
Do not use acetone, abrasive cleaners, or others special detergents to clean the panels.
RPfcirP Accpmhl.
Choose your site carefully before beginning assembly.
The ground surface must be perfectly flat and leveled and have a solid base such as
concrete, asphalt, deck etc.
Sort the parts and check according to the content parts list.
Please consult your local authorities if any permits are required prior to constructing
the product.
Tools & Equipment
T001 (Supplied)
During Assembly
When encountering these icons, you are requested to either
keep the screws slightly loose or to fully tighten the screws.
ir
This icon indicates
that the installer should
be inside the product.
Step!
This icon indicates that
11 the installer should be
outside the product.
Step 1: Please assemble the gazebo as per its instructions. Do not assemble the plastic
corner pieces (part #8327), the plastic clips (part #7829) and do not anchor to the base you
prepared in advance!
Step 2: Dismentle the internal foot-pads (part #212 or 8758).
Step 5: During assembly, from this step onwards, use a carton or other soft material below the
parts to avoid scratches and damages.
Step 8: Peel the film from the panels' edges before sliding them into the profiles, peel the
entire film once the assembly is complete.
Step 15: Note - done from inside the gazebo.
Step 26: Apply silicone on the inside in order to seal as shown in drawing a. Screws and
corner cover are supplied with the gazebo!
Step 27: Make sure the gazebo is leveled prior to anchoring the corner poles, use suitabled
screws and plugs as per your chosen base.
Step 29: Make sure the entire gazebo is leveled prior to anchoring it to the surface of your
choosing. Use suitable screws and plugs.
Step 30: Install the sealing strip on the outer side as shown in the diagram. Use mild soap if
needed.
*Tighten all screws when completing assembly.
Please note:
Anchoring this product to the ground is essential to its stability and rigidity,
and required in order for your warranty to be valid.