Installation Guide

» Tools & Equipment
 During Assembly
During assembly use a soft surface below the parts to avoid scratches and
damages.
Step 3: It is recommended to use a cardboard or other soft material under the
lowered corner in order to avoid scratches and peeling of paint.
Step 10: Optional!
Threading an electrical cable (for a fan or lamp etc.) is possible through the
roof & legs proles. There are 2 options through the leg; one of them requires a
special drill bit.
Step 15: Note that the triangle’s both sides are equal as shown in Diagram b.
Insert the screw into the hole in Prole 8200 without pressing the panel.
Step 23: Optional!
The gazebo comes equipped with a kit of 75 hooks Part 7829 (can be used for
hanging curtains / netting / owerpots etc.) If you have purchased curtains and
or netting kits please refer to their assembly instructions at this stage. Part 7829
is also supplied with those kits.
Step 25: Please level the proles’ legs and adapt screws and plugs to your
specic ground type.
Attention
•
Screws and plugs are not supplied.
•
Please tighten all screws when completing assembly.
•
Anchoring this product to the ground is essential to its stability and rigidity.
It is required to complete this stage in order for your warranty to be valid.
IMPORTANT
Please read these instructions carefully before you start to assemble this product.
Please carry out the steps in the order set out in these instructions.
Keep these instructions in a safe place for future reference.
 Care & Safety Advice
•
Please follow the instructions as listed in this manual.
•
Sort the parts and check against the contents list.
•
For safety purposes we strongly recommend the product to be assembled
by at least two people.
•
Some parts have metal edges. Please be careful when handling components.
Always wear gloves, shoes and safety goggles during assembly.
•
Do not attempt to assemble the Gazebo in windy or wet conditions.
•
Dispose of all plastic bags safely – keep them away from children’s reach.
•
Keep children away from the assembly area.
•
Do not attempt to assemble the Gazebo if you are tired, have taken drugs,
medications or alcohol, or if you are prone to dizzy spells.
•
When using a stepladder or power tools, make sure that you are following
the manufacturer’s safety advice.
•
Do not climb or stand on the roof.
•
Heavy articles should not be leaned against the poles.
•
Keep roof and gutters clear of snow, dirt & leaves.
•
Heavy snow load on roof can damage the Gazebo making it unsafe to
stand below or nearby.
•
This product was designed to be used mainly as a Gazebo.
If color was scratched during assembly it can be xed with the following tint:
Grey – RAL 7012
 Cleaning Instructions
In order to clean the Gazebo, use a mild detergent solution and rinse with
cold clean water.
Do not use acetone, abrasive cleaners, or other special detergents to clean
the panels.
EN
When encountering the information icon, please refer to the
relevant assembly step for additional comments and assistance.
13mm
5mm
3/16”
10mm
25/64”
SILICON \
CAULK
TOO1(Supplied)
82792_L_16.07_V2_MV_1-7