Instructions / Assembly
Notes During
Assembly
Use a soft platform below the
parts to avoid scratches and damages.
Product dimensions can be
adjusted to your specific needs:
1.The wall-mounting profile
(top-back) can be adjusted from 257 to 283 cm (101.2" to
111.4") above ground. The
adjusting is done when
measuring and drilling (Step 5).
Please note the installation
recommendations' height suggested in Diagram A.
It is possible to fix the Patio
Cover back wall height at the lowest point of 257 cm/101.2".
This method is optional if the
assembly conditions and exterior
walls do not allow to follow the suggested installation as
appears in the manual.
Please note that the product
appearance may slightly change as a result, however snow
load weight does not change.
2. Poles distance from the wall
can be adjusted from 160 to 210 cm (63" to 82.7") as
suggested in Diagram B1.
Poles distance from the side
edges can be adjusted from 5 to 54 cm (2" to 21.3") as
suggested in Diagram B2.
The adjusting is done after
assembly and before anchoring (Step 17) by sliding poles and
profile 8189+8190 at the roof
profiles' channels.
3. Wall mounting and distance
from the wall determine the roof angle and the total depth
of the product (distance of
gutter from the wall). Higher wall
mounting and shorter distance between wall and poles
increase the roof angle and
shorten the total depth as
suggested in Diagram C.
Steps
Step 8: Apply silicone sealants
above beam 8185, in order to prevent water from seeping
in.
Step 10: Make sure that the
angle between the back wall profile and the panel supporting
profiles is 90 degrees.
Step 15: Apply silicone sealants
on the inner part of 7997, and connect to the profile as
depicted in drawing 15a.
Step 15c: Do not tighten screw
8708 yet, in order to allow the final adjustments done in
step 16b.
Step 17a+1 7c: Please adjust the
poles (inside out and sideways) by sliding them to their
final position prior to
anchoring. Make sure that the
poles distance from the Patio cover side edge does not
exceed 54 cm/21.3".
Step 1 7b: Adjust the gutter
head's angle according to your needs and tighten screws 8708.
Please note: Anchoring this
product is essential to its stability and rigidity. It is required to
complete this stage
(Step 19) in order for your
warranty to be valid.
*Tighten all screws when
completing assembly.
Note:
The wall anchoring kit
supplied with this product is suitable only for concrete walls.
Other wall types need an
accordant wall fixation kit. (Contact your supplier)
II
257-283cm
101.2"-111.4"
5 54cm
2 "- 21.3"
5 54cm
2'- 21.3"
.
.
.
- 13°
.
+ 17°
*;
..
+
-
f i
-41-