Installation Guide
EN
IMPORTANT
Please read these instructions
carefully before you start to assemble this product.
Please carry out the steps in the
order set out in these instructions.
Keep these instructions in a
safe place for future reference.
>> Care and Safety advice
Please follow the instructions as
listed in this manual.
Sort the parts and check against
the list of contents.
For safety purposes we strongly
recommend that the product will be assembled
by at least two people.
Some parts have metal edges.
Please be careful when handling components.
Always wear gloves, shoes and
safety goggles during assembly.
Do not attempt to assemble the
Gazebo in windy or wet conditions.
Dispose of all plastic bags safely
- keep them away from children's reach.
Keep children away from the
assembly area.
Do not attempt to assemble the
Gazebo if you are tired, have taken drugs,
medications or alcohol, or if you
are prone to dizzy spells.
When using a stepladder or
power tools, ensure that you are following the
manufacturer's safety advice.
Do not climb or stand on the
roof.
Heavy articles should not be
leaned against the poles.
Heavy load of snow on roof can
damage the Gazebo making it unsafe to
stand below or nearby.
This product was designed and
produced for it's aimed purpose only.
If color was scratched during
assembly it can be fixed with the following tints:
Grey - RAL 7012
>> Cleaning instructions
In order to clean the Gazebo, use a
mild detergent solution and rinse with
cold clean water.
Do not use acetone, abrasive
cleaners, or other special detergents to clean the panels.
>> During Assembly
During assembly use a soft surface
below the parts
to avoid scratches and damages.
»You will need
(Supplied)
(These items are
not supplied)
When encountering the information icon,
please refer to the relevant
assembly step for additional comments
and assistance.
Step 6:
Carefully spread silicone glue along the
cross-section of the profile and at once
attach the profiles together. Recommended to
wipe the extra residue silicone.
Step 7:
It is recommended to use a carton or other soft
material under the lowered
corner in order to avoid scratches and peeling of
paint.
*This note also refers to steps 8,10,11
Step 10:
Optional - if you wish to add curtains - Please
thread the plastic clips through
the rail in each profile in order to hang
additional curtains (not supplied). Add
clips according to the specific quantity of curtain
rings.
Steps 11a+13a:
Please note that threading of the screws should
be done from the outside
Steps 12b+14a:
Please note that threading of the screws should
be made from the bottom up.
Afterwards please use a screwdriver for easy
screwing
Step 15b:
Please add silicone on the inner area of part #
7661 as illustrated
Step 21:
For this particular step must assist another
person! During insertions screw
#4008, push profile #7745 downwards (outside
the structure)in order to insert
the screw through the profile, as shown in
circled illustration (a).
Step 22a:
Please drill holes in the panels to be located
precisely parallel to the holes in
profiles # 7744 + # 7743
Step 23:
Please level the profiles' legs and adapt screws
and plugs to your specific ground
type.
Please note: Screws and plugs are not supplied*
Please Fasten all screws at the end of assembly