Instructions / Assembly

IMPORTANT
Please read these instructions
carefully before you start to assemble this product.
Please carry out the steps in the
order set out in these instructions.
Keep these instructions in a
safe place for future reference.
>> Care and Safety advice
Please follow the instructions as
listed in this manual.
Sort the parts and check against
the list of contents.
For safety purposes we strongly
recommend that the product will be assembled
by at least two people.
Some parts have metal edges.
Please be careful when handling components.
Always wear gloves, shoes and
safety goggles during assembly.
Do not attempt to assemble the
Gazebo in windy or wet conditions.
Dispose of all plastic bags safely
- keep them away from children's reach.
Keep children away from the
assembly area.
Do not attempt to assemble the
Gazebo if you are tired, have taken drugs,
medications or alcohol, or if you
are prone to dizzy spells.
When using a stepladder or
power tools, ensure that you are following the
manufacturer's safety advice.
Do not climb or stand on the
roof.
Heavy articles should not be
leaned against the poles.
Heavy load of snow on roof can
damage the Gazebo making it unsafe to
stand below or nearby.
This product was designed and
produced for it's aimed purpose only.
If color was scratched during
assembly it can be fixed with the following tints:
Grey - RAL 7012
>> Cleaning instructions
In order to clean the Gazebo, use a
mild detergent solution and rinse with
cold clean water.
Do not use acetone, abrasive
cleaners, or other special detergents to clean the panels.
>> During Assembly
During assembly use a soft surface below the parts
to avoid scratches and damages.
»You will need
(Supplied)
(These items are
not supplied)
i When encountering the information icon,
please refer to the relevant
assembly step for additional comments
and assistance.
Step 9:
Please make sure that the bolt head is
positioned on the external side of the
pole.
*This does not refer to step 11
It is recommended to use a carton or other soft
material under the lowered
corner in order to avoid scratches and peeling of
paint.
Step 10:
The use of a screwdriver is optional.
In order to insert the bolt through the profile,
please create a small gap by
pulling profile #7664 backward.
Step 18: Please drill the holes in the panel evenly
and in front of the holes in
profile #7663.
Fasten all nuts at the end of assembly.