Installation Guide
IMPORTANT
Please read these instructions
carefully before you start to assemble this product.
Please carry out the steps in
the order set out in these instructions.
Keep these instructions in a
safe place for future reference.
Care and Safety advice
Please follow the instructions
as listed in this manual.
Sort the parts and check
against the contents list.
For safety purposes we
strongly recommend the product to be assembled by at
least two people.
Some parts have metal edges.
Please be careful when handling components.
Always wear gloves, shoes and
safety goggles during assembly.
Do not attempt to assemble
the Gazebo in windy or wet conditions.
Dispose of all plastic bags
safely - keep them away from children's reach.
Keep children away from the
assembly area.
Do not attempt to assemble
the Gazebo if you are tired, have taken drugs,
medications or alcohol, or if
you are prone to dizzy spells.
When using a stepladder or
power tools, make sure that you are following the
manufacturer's safety advice.
Do not climb or stand on the
roof.
Heavy articles should not be
leaned against the poles.
Keep roof and gutters clear of
snow, dirt & leaves.
Heavy snow load on roof can
damage the Gazebo making it unsafe to
stand below or nearby.
This product was designed to
be used mainly as a Gazebo.
If color was scratched during
assembly it can be fixed.
» Cleaning instructions
In order to clean the Gazebo, use
a mild detergent solution and rinse with
cold clean water.
Do not use acetone, abrasive
cleaners, or other special detergents to clean the panels.
»Tools & Equipment
T001 (Supplied)
A
Attention
Please make sure you install the panels with the
UV protected side
out (marked with "THIS SIDE OUT") and peel the
film strip covering
the panels.
Please tighten all screws when completing
assembly.
Anchoring this product to the ground is
essential to its stability and rigidity.
It is required to complete this stage in order for
your warranty to be valid.
When encountering the information
icon, please refer to the relevant
assembly step for additional comments
and assistance.
During Assembly
During assembly use a soft surface below the
parts to avoid scratches
and damages.
Steps 3-12:
It is recommended to use a carton or other soft
material under the lowered
corner in order to avoid scratches and peeling
of paint.
Step 10:
Optional - if you wish to add Palram's
curtains/netting - Please thread 16 of the
plastic clips through the rail in each of the four
profiles in order to hang the
curtains/netting (not supplied).
Steps 10a+12a:
Please note that threading of the screws should
be done from the outside
Steps 12+14:
Please note that threading of the screws should
be made from the bottom up.
Step 15b:
Please add silicone on the inner area of part
#8327 as illustrated
Step 21a:
Please drill holes in the panels to be located
precisely parallel to the holes in
profile #7663.
Step 22:
Please level the profile's legs and adapt screws
and plugs to your specific
ground type.