Specifications

Sh e l v i n g
PG 8 2016 SPECIFICATION GUIDE & PRICE LIST
Durecon WooD Shelving
Pr o d u c T Ma T e r i a l S & fi n i S h e S
Natural Walnut Walnut Finishes
Add 20% to list The following stain is available, add 30% to list
Natural Clear – DW-NA Java – DW-JA
Natural Cherry Cherry Finishes
Add 20% to list The following stains are available, add 30% to list
Natural Clear – C-NA Honey Oak – C-HO Richmond Cherry – C-RC
Natural Red Oak Red Oak Finishes
Standard The following stains are available, add 10% to list
Natural Clear – O-NA Castle Oak – O-CO Honey Oak – O-HO English Oak – O-EN Victorian Cherry – O-VI
Mahogany – O-MA Richmond Cherry – O-RC Java – O-JA Wenge – O-WE
WOODS & FINISHES:
Natural Maple Maple Finishes
Standard The following stains are available, add 10% to list
Natural Clear – M-NA Honey Oak – M-HO Castle Oak – M-CO Richmond Cherry – M-RC Mahogany – M-MA
Victorian Cherry – M-VI Java – M-JA Wenge – M-WE English Oak – M-EN
HARDWOODS: All hardwood materials used in the manufacturing of P2 products shall be Northern grown
hardwoods. Hardwoods will be air and kiln dried to a moisture content of 5-7%. All hardwoods shall be of grade
“A” material, free of material stains, imperfections, conformity of grain, texture and color. Hardwood species shall be
Northern grown Red Oak, Clear White Northern Maple and Birch. American Cherry and Honduras Mahogany and
Walnut are available. Please inquire for pricing.
VENEER: Exposed face veneers shall be not less than 1/28" thick plain sliced veneers. Veneers are to be selected for
conformity of grain direction and color. Veneers are to be stitched tightly in a book match, slip match or plain sliced
configuration. Unexposed veneers are to be of hardwood but not selected for color, or grain quality. Veneers are not
to be lap joined or reveal any tape or glue lines.
PARTICLE BOARD CORE: The particleboard shall be formed of wood chips, bonded with a water resistance
adhesive. The particleboard material is to be of a high density 45 Ibs/cu. ft. having a minimum average modules of
rupture of 2400 psi and a minimum average modules of elasticity of 4,000,000 psi.
VENEER CORE: Veneer core is to be constructed with odd numbers of plies. Each ply is to be laminated in pairs and
cross banded in opposite directions with grain direction at a 90 degree angle to the grain of the center core. All plies
are to be free from knots, wrinkles, laps or other natural or manufacturing defects.
HIGH PRESSURE LAMINATE: Work surface laminate shall be .050" thick and used with balancing backer sheet of
no less than .028" thick. Laminate shall conform to standards set by the National Electrical Manufactures' Association
(NEMA).
FINISHING PROCEDURES: All materials shall be inspected and treated with a final sanding and polishing operation
before any staining and final finishing can be performed. All machine and mill marks are to be removed. Once
the polishing and sanding has been performed, the furniture will then undergo the following stain and finishing
procedures:
Step 1 A base stain will be uniformly applied, wiped and then allowed to dry under factory controlled conditions.
Step 2 A uniform coat of sealer will be applied and allowed to dry.
Step 3 Sealer will be lightly sanded using 240 grit silicon paper.
Step 4 A catalytic lacquer of 34-45 degree sheen is evenly applied and allowed to dry under factory controlled conditions.