Instructions / Assembly

SWING
ASSEMBLY INSTRUCTIONS
HARDWARE INCLUDED:
(1) 2 ¼” bolt
(6) 3 ½” bolts
(11) washers
(7) Nuts
(2) chain assembly
QUALITY AMISH-MADE FURNITURE
1) Place pre-assembled seat on a level surface. Align
3 pre-drilled holes on seat with the 3 pre-drilled
holes on the pre-assembled back supports (see
figure 1).
2) Secure center support with 2 ¼” bolt, washer and
nut. Secure the end supports with 3 1/2” bolts,
washers, and nuts (see figure 2). Hand tighten.
3) Attach chain assembly to swing by inserting 3 ½”
bolt through the last link on shortest chain length
through a washer into pre-drilled hole in back end of
arm rest, then through pre-drilled hole in bench
back. Add second washer and nut (see Chain
Assembly diagram and figure 3). Repeat to attach
medium chain length to front end of arm rest, then
through front of seat (see figure 4). Repeat to
attach 2nd chain assembly to arm rest on other side
of swing.
4) Wrench tighten all nuts and bolts.
Figure 1 Figure 2
Figure 3
Chain Assembly
Finished SwingFigure 4
SEAT SUPPORT
ARM REST
Note on Chain Assembly:
Chain assembly has 3 distinct
lengths
Long - for hanging swing
Medium - Attaches to front of
arm rest
Short - Attaches to back of
arm rest
Important Note:
Your furniture has been kiln-dried and
ready to stain, paint or water seal to
help preserve it and keep it looking
nice longer. Please note, exposure of
all woods to outdoor elements can
cause fading, warping, cracking,
shrinking or expansion. The
manufacturer and distributor of this
product cannot be held responsible for
damage or changes caused by
natural weathering.
For support, contact [phone], [e-mail], or visit palmettocraft.com
QUALITY AMISH-MADE FURNITURE
Complete assembly videos can be found on palmettocraft.com