Instructions / Assembly

ADIRONDACK
ASSEMBLY INSTRUCTIONS
HARDWARE INCLUDED:
(6) 3” Bolts
(6) Washers
(6) 1/4” Nuts
(4) 2 1/2” Screws
1) Place pre-assembled seat on a level surface. Align
pre-assembled back with pre-drilled holes on seat
and fasten with (4) 2 ½” screws using pre-drilled
holes (see figure 1).
2) Position pre-assembled arm/leg assembly on seat
and back (curved side of armrest facing in), aligning
with pre-drilled holes (see figure 2). Secure by
inserting (3) 3”inch bolts through pre-drilled holes
(see figure 3). Add washer and nuts (see Bolt
Assembly diagram). Hand tighten. Repeat to
attach arm/leg assembly to other side of chair.
3) Wrench tighten all nuts and bolts.
Figure 1 Figure 2
Bolt Assembly Diagram
Figure 3
Finished Chair
WOOD
WASHER
NUT
Important Note:
Your furniture has been kiln-dried and
ready to stain, paint or water seal to
help preserve it and keep it looking
nice longer. Please note, exposure of
all woods to outdoor elements can
cause fading, warping, cracking,
shrinking or expansion. The
manufacturer and distributor of this
product cannot be held responsible for
damage or changes caused by
natural weathering.
QUALITY AMISH-MADE FURNITURE
For support, contact [phone], [e-mail], or visit palmettocraft.com
Complete assembly videos can be found on palmettocraft.com