Instructions / Assembly

1. Lay table top face-down on level surface. Attach 4 legs by
inserting (4) 2 ½” bolts through pre-drilled holes in table top into
pre-drilled holes in the top of legs. Add washers and nuts
(see figure 1). Hand tighten.
4. Align pre-drilled holes in triangle shelf supports with pre-drilled
holes in front of backboard. Attach using (4) square-head screws
(see figure 4a). Finish securing the shelf by driving the last (2)
square-head screws into the pre-drilled holes in the back of the
backboard (see figure 4b).
QUALITY AMISH-MADE FURNITURE
Palmetto Boon Table
Assembly Instructions
Complete assembly videos can be found on
palmettocraft.com
2. Turn table onto its side. Attach middle shelf by inserting (4) 2
½” bolts through pre-drilled holes in middle of legs into pre-drilled
holes in middle shelf. Add washers and nuts
(see figure 2). Hand tighten.
5. Attach backboard to table by inserting (2) 2 ½” bolts through
pre-drilled holes in backboard into pre-drilled holes in table. Add
washers and nuts. Hand tighten.
Potting Bench: 5a. Attach backboard upright (see figure 5a)
Serving Table: 5b. Attach backboard upside down (see figure 5b)
3. Attach small shelf to triangle shelf support using (2) square-
head screws through the pre-drilled holes in the top of the shelf
(see figure 3). Repeat with 2nd triangle shelf support.
6. Wrench tighten all nuts and bolts.
Important Note:
Your furniture has been
kiln-dried and ready to stain,
paint or water seal to help
preserve it and keep it looking
nice longer. You may need
to tighten all bolts and nuts
periodically due to the natural
expanding/contracting of
wood. Please note, exposure
of all woods to outdoor
elements can cause fading,
warping, cracking, shrinking or
expansion. The manufacturer
and distributor of this product
cannot be held responsible for
damage or changes caused by
natural weathering.
Best Tools Needed
For Assembly:
Hardware
Included:
• Drill • Socket • Hammer
Shown as potting benchShown as serving table
• (10) 2 1/2” bolts
• (10) Washers
• (10)7/16” Nuts
• (10) Square-head screws
• Square-head drill bit
For support, contact [phone], [e-mail], or visit palmettocraft.com