User's Manual
Table Of Contents
- Permalog®
- Patroller
- Scope
- Introduction
- Safety warning
- Battery installation
- Checking Battery voltage
- Connections and interfaces to the Patroller
- Operating the Patroller
- On-Screen Menus
- Specifications
- Fuse information
- Conditions of Use of Permalog® System
- Permalog 1 Deployment Instructions
- Redeployment
- Permalog 2 Deployment Instructions
- Redeployment
- Warranty
- Patents
8
Operating the Patroller
The Patroller uses on-screen menus for most of its operational functions. The
key required for each function is highlighted on the display in inverse video.
ESC can be used to exit a function and return to the menu above. Pressing
ESC several times will always return you to the Main Menu.
Press the on-off button to switch the Patroller on. The unit will display the
Palmer logo and firmware version number for 5 seconds then switch
automatically to Leak Patrol mode. During the 5 second period, pressing ENT
takes you directly to Leak Patrol mode and pressing any other key takes you
to the Main Menu.
The backlight for the display will remain on when switched on if the Patroller is
connected to a DC supply. When powered by the Patroller only, the backlight
will switch off after 10 seconds to conserve power.
Front view of
Patroller
High, Medium and Low
sensitivity ranges